Wedi Fundo Riolito neo Instrucciones De Montaje página 6

wedi Fundo Riolito neo  Tools | Herramientas | Outillage
 Have extra 2 × 4 blocking installed over bottom plate between studs along
EN
to support wedi building panel to shower base transition area.
 Subfloor is stable, even and loadbearing, and meets deflection criteria of
maximum L/360 and requirements as per IRC. Wooden or concrete structural
substrates are dry and sufficiently loadbearing considering live and dead load.
Wood and Steel framing is sufficiently loadbearing, plum and square.
 Floor drain assembly below floor is stabilized, fixed and supported in position,
and will not sink under water load.
 Only wedi products (Building Panels, Curb, Joint Sealant and Fasteners)
are used for wedi Fundo Shower System assembly.
 Installer has received instructions from wedi technical sales staff or is infor-
med about proper installation methods as described.
 wedi shower bases can be cut to size using a skilsaw. The Z notch channel
must be remade and cleaned from sawdust or other possible contamination.
 Follow applicable state or local plumbing codes requiring specific and
dimensioned waterproofed areas for a shower system or other wet room
installation. Requirements in this manual supersede local plumbing codes;
they extend and are not in conflict. wedi Shower Systems or other wet
room installations in which non-wedi product is also used require specific
project recommendations by wedi and may reduce the extent and installa-
tion area of protection offered by wedi's warranty.
EN  Bucket
 Utility Knife
 Caulk Gun
 Flat Head Screwdriver
 Paper Towels
 Saw Horse
 Extension Cord for Powertools
 Shop vacuum cleaner
 Cubo
ES
 Cuchillo multiuso
 Escuadra triangular de acero
 Desarmador de punta plana
 Papel absorbente
 Caballete
 Cable de extensión para
herramientas eléctricas
 Aspiradora de taller
 Seau
FR
 Couteau universel
 Équerre triangulaire
 Tournevis à bout plat
 Essuie-tout
 Chevalets
 Rallonge pour outillage électrique
 Aspirateur d'atelier
 Masque respiratoire (N95)
 Notch Trowel
 Straight Edge /
T Square 5 ft (1524 mm) or longer
 Cordless Drill or Hammer
 Level
 Tape Measure
 ABS or multipurpose pipe cement glue
 Safety Glasses
 Llana ranurada
 Regla o regla T de al menos 5 ft (1524 mm)
 Pistola para calafatear
 Martillo o taladro inalámbrico
 Nivel
 Cinta métrica
 Cemento cola para tubería
de ABS o multiusos
 Gafas de seguridad
 Truelle dentelée
 Règle/Équerre en T de 1524 mm ou plus
 Pistolet à calfeutrer
 Perceuse sans fil ou marteau
 Niveau
 Mètre ruban
 Ciment-colle pour tuyau polyvalente
ou pour ABS
 Ensure that no fasteners are used and penetrate through any horizontal building
panel or shower base surfaces in shower or immediate wet rooms. This includes
tub decks, pony shower wall tops, curb tops made from building panels, seat
tops. wedi panels in such areas are installed in a full surface applied thinset
mortar setting bed.
 Seams in the assembly, which are not flat transitions or right angle inside corner
connections, are treated with these extra steps:
1) Assembly parts are installed tight and offer a minimum of 1/2" (12.7 mm)
wide continuous contact/ adhesion surface between two parts, inside which
wedi joint sealant is continuously applied.
2) wedi joint sealant is applied over these seams topically, and 1" (25.4 mm)
wide on both sides of the seam.
3) wedi mesh tape is installed over these seams and covered with joint sealant
1" (25.4 mm) wide on both sides of the seam.
6
 Drill with Thinset Mixer
 Speed Square
 Handsaw
 Solid Putty Knife
 Circular Saw
 Permanent Marker
 Inside PVC Pipe Cutter
 Respirator Mask (N95)
 Taladro con mezcladora
de mortero cola
 Serrucho
 Espátula sólida
 Sierra circular
 Rotulador permanente
 Cortatubos para el interior
de tubería de PVC
 Máscara de respiración (N95)
 Perceuse avec mélangeur
de ciment-colle
 Scie égoïne
 Couteau à mastiquer rigide
 Scie circulaire
 Marqueur permanent
 Coupe tuyau PVC par l'intérieur
 Lunettes de protection