Troubleshooting - Homelite UT41113 Manual Del Operador

SPOOL REPLACEMENT
See Figure 14.
Use only .065 in. diameter monofilament line. Use original
manufacturer's replacement line for best performance.
 Unplug the string trimmer.
 Push in tabs on side of spool retainer.
 Pull spool retainer up to remove.
 Remove spool.
 To install the new spool, make sure the two lines are
captured in the slots opposite each other on the new
spool. Make sure the end of each line is extended
approximately 6 in. beyond each slot.
 Install the new spool so that the lines and slots align with
the eyelets in the string head. Thread the lines into the
eyelets.
 Pull the lines extending from the string head head so the
line releases from the slots in the spool.
 Reinstall the spool retainer by depressing tabs into slots
and pushing down until spool retainer clicks into place.
LINE REPLACEMENT
See Figures 14 - 15.
 Unplug the string trimmer.
 Remove the spool from the string head.
PROBLEM
Lines will not advance when using the
Auto Feed Head:
Grass wraps around driveshaft housing
and string head:
Motor fails to start when switch
trigger is depressed.
This product has a Two-year Limited Warranty for personal, family, or household
use (90 days for business or commercial use). For warranty details, visit
www.homelite.com or call (toll free) 1-800-242-4672.
MAINTENANCE
 Cut two pieces of line, each being approximately
 Insert the first line into the anchor hole in the upper part
 Repeat above step with second line, using the bottom
 Replace the spool retainer, spool, and the spool retainer.
STORING THE TRIMMER
 Depress telescoping shaft coupler and set at shortest
 Clean all foreign material from the trimmer.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden

TROUBLESHOOTING

POSSIBLE CAUSE
1. Lines are welded to themselves.
2. Not enough line on spool.
3. Lines are worn too short.
4. Lines are tangled on spool.
1. Cutting tall grass at ground level.
1. Power cord is not plugged in or
connection is loose.
2. Household circuit breaker is tripped.
Page 9 — English
NOTE: Remove any old line remaining on the spool.
9 ft. (2.7 m) long. Use only .065 in. (1.65 mm) diameter
monofilament line.
of the spool. Wind the first line around the upper part of
the spool counterclockwise, as shown by the arrows on
the spool. Place line in the slot on upper spool flange,
leaving about 6 in. (152 mm) extended beyond the slot.
Do not overfill. After winding the line, there should be
at least 1/4 in. (6 mm) between the wound line and the
outside edge of the spool.
part of spool. Do not overfill.
Refer to Spool Replacement earlier in this manual.
setting.
chemicals and de-icing salts.
1. Lubricate with silicone spray.
2. Install more line. Refer to Line
Replacement earlier in this manual.
3. Pull both lines while pressing button.
4. Remove lines from spool and rewind.
Refer to Line Replacement earlier in
this manual.
1. Cut tall grass from the top down to
prevent wrapping.
1. Plug in the power cord.
2. Check circuit breaker.
SOLUTION