Reprocessing The Mask Between Patients; Technical Specifications - ResMed AirFit N10 Manual De Instrucciones

Cleaning the mask at home
The mask and headgear can only be gently handwashed in
warm (30°C) water using mild soap.
Daily/After each use:
 To optimise the mask seal, facial oils should be removed
from the cushion after use.
 Handwash the separated mask components (excluding
headgear and soft sleeves).
 If the vent or swivel requires cleaning, use a soft bristle
brush.
Weekly:
Handwash the headgear and soft sleeves. The headgear may
be washed without being disassembled.

Reprocessing the mask between patients

This mask should be reprocessed when used between
patients. Cleaning, disinfection and sterilisation instructions
are available from the ResMed website,
www.resmed.com/masks/sterilization. If you do not have
internet access, please contact your ResMed representative.

Technical Specifications

Pressure-flow curve – The mask contains passive venting to
protect against rebreathing. As a result of manufacturing
variations, the vent flow rate may vary.
Pressure (cm H O)
2
4
11
17
24
30
Deadspace: Empty volume of mask to swivel. The deadspace of
the mask varies according to cushion size.
Therapy pressure (cm H
2
Resistance: Drop in pressure measured (nominal) (cm H
at 50 L/min
at 100 L/min
6
AirFit N10
Flow (L/min)
20
35
44
54
61
104 mL (Wide)
O)
4-30
0.4
1.2
O)
2