Hotpoint Ariston HNP 6.5 CM X/HA Manual De Instrucciones página 36

GB
Power
Halogen 25 W 2 x 25 W
Halogen 20 W 2 x 20 W
*
LED Risk Group 1 according to Standard EN 62471
The hoods are conforming to the following EC
Directives:
• "Low voltage" Directive 2006/95/EC (12-12-2006)
• "EMC" Directive 2004/108/EC (15-12-2004)
PYRAMID controls
Models with mechanical keypad
HNP 6.5 CM X/HA
HNP 6.6 AM W/HA
HNP 9.6 AM W/HA
HNP 9.6 AM K/HA
HNP 9.6 AM X/HA
HNP 6.6 AM K/HA
HNP 6.6 AM X/HA
HRP 9.8 CM (OW)/HA
7HHP 6 R (OW)/HA
HRP 9.8 CM (AN)/HA
7HHP 6 R AN/HA
HRP 6.5 CM (OW)/HA
HRP 6.5 CM (AN)/HA
HRP 9.6 CM (OW)/HA
HRP 6.5S CM (OW)/HA
HRP 6.5S CM (AN)/HA
T1 T2
T1 Motor reset
Pressing the button while the hood is in operation turns it
OFF.
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Lights ON/OFF
*
Only available in certain models
36
Voltage Cap Dimensions
230 V G9
12 V G4
HYM 60 IX/HA
HPM 61 IX/HA
T3 T4 T5
Models with soft button keypad
L40xØ14
L30xØ10
T1 T2
T1 Motor reset
Pressing the button while the hood is in operation turns it
OFF.
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Booster
Pressing the button sets the hood to high speed. After 5
minutes, the hood returns to the previous speed; pressing
a speed button (T2, T3 or T4) quits booster mode and sets
the selected speed.
T6 Lights ON/OFF
Grease/odour filter warnings
The T2 icon flashes to indicate that the grease filter is
saturated, while T3 flashes to indicate that the odour filter
is saturated, and if both are flashing then both filters are
saturated. You must then clean/replace the grease filter (A)
or odour filter (B) or both, accordingly (see "Maintenance
and care").
To reset the filter counter:
Hold down T4 for three seconds while the hood is on.
The warning led flashes three times, then returns to its
normal mode If both filter warnings are active at the same
time, you must reset each separately.
The first sequence resets the grease filter, while the second
sequence resets the odour filter.
HNP 9.6 AB X/HA
B
T3 T4 T5 T6