Honeywell RET97E5D Wi-Fi Serie Guia Del Usuario página 16

Installing your thermostat
Wiring (conventional system)
7A Wire the Wi-Fi thermostat to your conventional system.
a Starting with the C Wire, match the sticky tag on the
wire to the terminal labels.
You must have a C wire. See page 13.
b Loosen screw, insert wire on inside edge
of terminal, then tighten screw.
c Verify wire is firmly secured by gently
pulling on wire.
d Repeat steps a–c for all other wires.
e Push any excess wire back into the wall
opening after all wires are installed.
f Continue to page 20.
Labels don't match?
wiring key on pages 16–17.
69-2803ES—03
See alternate
14
Remove metal jumper
only
if you have both
R and RC wires
W2 G W C
K Y2 Y R RC
K L G O/B C Y
AUX/E
Note:
The wiring for your
application might be different
from the wiring shown above.
CONVENTIONAL
R RC
HEAT PUMP
MCR33878