Door Conversion - Domo DO986BFK Manual De Instrucciones

· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic
coating. Heat sources nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to
from very quickly on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the
voltage stated on the rating label of your appliance corresponds to the
voltage in your home. A different voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible
for damages that may occur as a result of usage without grounding.
· After installation, leave the freezer for 8 hours before turning it on. This
way the refrigerant can settle.
· Allow the appliance to run empty for 24 hours so the compartment can
cool to the appropriate temperature.
· This appliance is designed to operate in ambient temperature between
16°C and 38°C. If these temperatures are exceeded, i.e. colder or
warmer, the appliance will not operate correctly.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.

DOOR CONVERSION

If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty.
After reversing the door, leave the appliance alone for 8 hours before switching it on. This allows the
Door Reversibility Door Reversibility Door Reversibility
coolant to set. We recommend using a slotted screwdriver, a Phillips screwdriver, and a wrench (not
included), as well as the components supplied below.
%HIRUH UHYHUVLQJ WKH GRRU SOHDVH EH SUHSDUHG EHORZ WRROV DQG PDWHULDO VWUDLJKW VFUHZGULYHU FURVV %HIRUH UHYHUVLQJ WKH GRRU SOHDVH EH SUHSDUHG EHORZ WRROV DQG PDWHULDO VWUDLJKW VFUHZGULYHU FURVV %HIRUH UHYHUVLQJ WKH GRRU SOHDVH EH SUHSDUHG EHORZ WRROV DQG PDWHULDO VWUDLJKW VFUHZGULYHU FURVV
Door Reversibility
VFUHZGULYHU VSDQQHU DQG WKH FRPSRQHQWV LQFOXGHG LQ WKH SRO\ EDJ VFUHZGULYHU VSDQQHU DQG WKH FRPSRQHQWV LQFOXGHG LQ WKH SRO\ EDJ VFUHZGULYHU VSDQQHU DQG WKH FRPSRQHQWV LQFOXGHG LQ WKH SRO\ EDJ
Hinge cover plate
%HIRUH UHYHUVLQJ WKH GRRU SOHDVH EH SUHSDUHG EHORZ WRROV DQG PDWHULDO VWUDLJKW VFUHZGULYHU FURVV
/HIW 'RRU +LQJH &RYHU [  /HIW 'RRU +LQJH &RYHU [  /HIW 'RRU +LQJH &RYHU [ 
VFUHZGULYHU VSDQQHU DQG WKH FRPSRQHQWV LQFOXGHG LQ WKH SRO\ EDJ
/HIW 'RRU +LQJH &RYHU [ 
 8nscrew top hinge cover and disconnect connectors of door switch and harness.  8nscrew top hinge cover and disconnect connectors of door switch and harness.  8nscrew top hinge cover and disconnect connectors of door switch and harness.
1. Loosen the screws of the hinge cover plate and remove the plate. Disconnect both connectors of the
 8nscrew top hinge cover and disconnect connectors of door switch and harness. cables.
2.Unscrew top hinge 2.Unscrew top hinge 2.Unscrew top hinge
2.Unscrew top hinge
www.domo-elektro.be
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Keep enough space of door open.
Keep at least 50mm gap at two sides.
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Top door stopper
Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Upper Door x 1
Left Aid-Closer on Upper Door x 1
1007
1007
13
Bottom door stopper
Left Aid-Closer on Lower Door x 1 Left Aid-Closer on Lower Door x 1 Left Aid-Closer on Lower Door x 1
Left Aid-Closer on Lower Door x 1
13
1071
49
DO986BFK