Door Conversion - Domo DO990TDK Manual De Instrucciones

· Avoid direct sunlight and heat. Direct sunlight may affect the
acrylic coating. Heat sources nearby will cause higher electricity
consumption.
· Avoid very moist places. Too much moisture in the air will cause frost
to from very quickly on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that
the voltage stated on the rating label of your appliance corresponds
to the voltage in your home. A different voltage could damage the
appliance.
· The appliance must be grounded. The manufacturer is not responsible
for damages that may occur as a result of usage without grounding.
· After installation, leave the freezer for 8 hours before turning it on.
This way the refrigerant can settle.
· Allow the appliance to run empty for 24 hours so the compartment
can cool to the appropriate temperature.
· This appliance is designed to operate in ambient temperature
between 16°C and 38°C. If these temperatures are exceeded, i.e. colder or warmer, the appliance will
not operate correctly.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.

DOOR CONVERSION

If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty. It is recommended that two people carry out the works.
1. Remove the upper hinge cover plates.
2. Remove the screws from the top hinge with a Phillips screwdriver.
3. Unscrew the pin and pinion from the metal hinge plate and fasten it on the other side.
www.domo-elektro.be
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Keep enough space of door open.
Keep at least 50mm gap at two sides.
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
1007
902 mm
1007
13
13
1052 mm
1071
37
DO990TDK