Safety Checks; Start-Up / Working; After Operation; Routine Maintenance - Stiga 110 Combi Pro EL QF Manual De Uso

• mow, chop and deposit the grass on
the ground (mulching effect)
• mow the grass and discharge it on
the ground from the rear section
The cutting-means assembly is delivered
ready to operate in "mulching" mode.
To remove the grass from the rear of
the cutting-means assembly
• Loosen and remove the knob (fig. 15.A)
that fastens the chute (fig. 15.B).
• Remove the chute (fig. 15.B).
• Keep the knob and chute in a
safe place for further use.

6.2 SAFETY CHECKS

Run the following safety checks and
check that the results correspond to
those outlined on the tables.
Always carry out the safety
checks before use.
6.2.1 General check
Object
Electrical cables.
Screws on the machine
and on the cutting means
Canvas guard
Test guide with cutting
means engaged (See
specific instructions
supplied in the
machine manual)
6.2.2 Machine operating test
When performing the operations below,
please read the instructions provided in the
ride-on mower with front deck manual.

6.3 START-UP / WORKING

When performing the operations below,
please read the instructions provided in the
ride-on mower with front deck manual.

6.4 AFTER OPERATION

• Clean (par. 7.4).
• Check the machine for any
damage. If necessary, contact the
authorised service centre.
Result
All insulation intact.
No mechanical damage.
Correctly tightened
(not loose)
Correctly positioned
No abnormal vibrations.
No abnormal noise.

7. ROUTINE MAINTENANCE

7.1 GENERAL INFORMATION

IMPORTANT The safety regulations to
follow during machine use are described
in chapter 2. Strictly comply with these
indications to avoid serious risks or dangers.
All maintenance and control
interventions must be performed with
the machine stationary and the motor
switched off. Before cleaning or doing
maintenance work, take out the ignition
key and read the relevant instructions.
Use suitable clothing,
protective gloves and goggles
during maintenance work.
• The frequency and types of maintenance
are summarised in the "Maintenance
Table". The table will help you maintain
your machine's safety and performance.
It summarises the main interventions to
be made and the frequency applicable
to each of them. Carry out the relevant
intervention according to the first deadline.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.

7.2 WASH AND MAINTENANCE POSITION

1. Always apply the parking brake to prevent
the machine from moving (Please also
read the instructions provided in the ride-
on mower with front deck manual).
2. Disconnect the machine power
cable connector (fig. 14.A).
3. Release the rear section of the
cutting-means assembly:
– Grasp it as seen in (fig. 16.A)
and lift it slightly.
– Rotate the support arms release
lever (fig. 16.B) and slowly lower
the cutting-means assembly.
– Perform the operation on both sides.
4. Grasp the front edge of the cutting-
means assembly (fig. 17.A) and slowly
lift it until it reaches maximum height and
clicks into position. The cutting-means
assembly remains blocked in this wash
and maintenance position (fig. 18).
EN - 7