Publicidad
Idiomas disponibles
Idiomas disponibles
Changing and Adjusting the Saw Blade
7) First loosen the two knurled screws beneath the worktable and remove the worktable. Next, loosen the knurled screws of the white hood and remove the
hood. Now press the upper band roller downward to remove the saw blade.
8) Place the new saw blade onto the middle of the lower band roller. Push down the upper band roller and put the saw blade onto it as well.
9) Manually turn the lower roller approx. 2-3 rotations in the running direction. This will automatically centre the saw blade. The tension spring keeps the
saw blade under tension. Turn on the machine to check the running position of the saw blade. The saw blade should run approx. 5-10 mm from the edge of
the lower roller. The position of the saw blade can only be corrected by carefully turning the knurled nut on the back side of the saw. Please run a few
tests to set the desired position. Then turn the machine off again.
10) Without pressure, tighten the eccentric below the rocker bar. Finally, put the hood and the worktable back in place and tighten the fastening screws.
7)
Sawing Glass
11) Set your glass on the worktable. Guide the glass along the saw blade using gentle pressure, always
sawing toward the transparent blue side. When sawing curves, turn the glass smoothly without jerking!
The glass should be pressed against the saw blade only enough that the saw blade does not get pushed
from the roller. Familiarize yourself with the correct sawing pressure by first sawing some trial pieces.
At the end of a cut, stop pressing against the saw blade so that the glass does not splinter.
Sawing other Materials
For other materials the same applies as for glass. However, the sawing pressure may be different. Be sure
that you always keep the object you are sawing firmly on the worktable.
Cleaning and Maintenance
After you have finished using the saw, rinse it off with clean water.
Safety Information
Always wear safety glasses and safety gloves when working with the band saw!
Spare Parts
The Bohle DIAMANTOR band saw attachment is very wear-resistant. However, should you need spare parts, we always have the following articles in stock:
Saw blade 3.4 mm wide
TG H201
Coolant sponge
TG H214
Drive cone
TG H216.01
Fastening band with hook
TG H218.01
Drive roller
TG H213.01
Bohle AG
P.O.Box 1163 · D-42755 Haan
www.Bohle.de
8)
9)
11)
10)
Publicidad
