Tecno-gaz PEARL Manual Del Usuario página 43

Defect Cause
Pushing START
Lack Power
button the
1
device does
Fuse/s burned
not work
The head of
The screw T joint of
the lamp is not
secondary S3 (fg. 6) is
2
in the desired
not tight enough.
location
Diagnostics and troubleshooting
If the device does not work properly or not at all, contact the manufacturer
directly or an authorized service centre.
It is not possible to work directly on the device.
The only work allowed is the following:
• Cleaning and disinfection (maintenance and troubleshooting)
• Checking the efficiency of the LEDs: Reduction in the light power, as a
consequence of LEDs that are not working or power supply problems,
reduces the whitening process.
Intervention
Control plug fit correctly in sockets
Replace the fuse/s FA1 as tag
Once torqued elements G and V (fg. 6), taking the head
lamp, tighten gradually screw T verifying that the head
remains in place and can move simultaneously under
the action of
19
ENGLISH