Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
UNPACKING, ASSEMBLY & SETUP
CAUTION: FOLLOW ALL OF THE ASSEMBLY & INSTALLATION INSTRUCTIONS COMPLETELY BEFORE CONNECTING
THE SAW TO A POWER SOURCE OR TURNING THE MOTOR ON.
Carefully open the container and remove all saw components and packing materials. Ensure that you have checked each
item with the exploded view on Page 8 before discarding the container or packing materials. The contents of the
container are as follows:
• Cutting Head Assembly
• Closed Wrench
• Owner's Manual
The following pages illustrate step by step the installation of various components and operation of the saw.
Read instructions completely before operating this saw!
CUTTING-HEAD ASSEMBLY INSTALLATION
CAUTION: FOLLOW ALL OF THE ASSEMBLY & INSTALLATION INSTRUCTIONS
COMPLETELY BEFORE CONNECTING THE SAW TO A POWER SOURCE OR TURNING
THE MOTOR ON.
1. Remove the motor mount block and motor from the packaging, loosen the
wing screws enough to permit the motor mount to fit on the frame upright post.
2. Set the motor mount block on the frame upright post, so it is completely seated,
i.e. in the full down position. Then tighten the 2 wing screws to hold the motor
block securely in place.
BLADE & BLADE GUARD INSTALLATION
1. Remove the blade guard and set it aside in the cutting head.
2. Raise the blade guard to the highest level and tighten the blade guard wing
screw. Then, remove the blade shaft nut and outer flange.
3. Place the blade onto the shaft, pushing it up against the inner flange. Make sure
the directional arrow is pointing in the direction of rotation.
4. Replace the outer flange and blade shaft nut. With one hand, hold the blade and
tighten the blade shaft nut with your free hand. Make certain the nut is firmly
tightened with wrench provided. DO NOT OVER-TIGHTEN!
5. Lower the blade guard into position and tighten the wing screw.
6. To remove the blade, reverse the installation steps.
WATER PUMP INSTALLATION
1. Remove the water pump from its box and ensure that it is not cracked or
damaged in any way
2. Attach the end of the plastic tubing, hanging down from the blade guard, to
the water pump nipple.
3. Place the water pump in the rear of the water tray on its side, with the water
pump nipple also on its side.
4. Next, fill the water tray with water so that its level is higher than the water
intake nozzle.
5. Keep the power cord out of the water and plug it into the 3-prong receptacle
on the back of the cutting head assembly. The pump is activated by the
ON/OFF switch on the electric motor.
NOTE: WATER PUMP SAFETY GUIDELINES & MAINTENANCE INSTRUCTIONS
ARE LISTED BELOW. PLEASE READ CAREFULLY AND COMPLETELY.
• 45° / 90° Rip Guide
• 7" Saw Blade
• Blade Guard Accessory
• Water Pump
• Saw-Frame Assembly
- 6 -
• Fiberglass-Impregnated
Plastic Water Tray
Publicidad
Tabla de contenido
