Product Specifications; Assembly - QEP 22500Q Instrucciones De Funcionamiento

Rip Guide
Angle Guide
On/Off
Switch
fIGurE 3
The durable 7 inch blade cuts tile up to 1 1/4
in (33 mm) thick. The adjustable rip and angle
guides allow 90° rip cuts and 0° to 45° miter
cuts on both the right and left sides. The left
cutting table is hinged so it can be adjusted
for 15°, 30° and 45° miter cuts. The right table
has a built-in water reservoir for cooling the
blade. The water reservoir has a side overflow
hole for proper water level. The built-in handle
allows easy transporting. The convenient
storage area on bottom holds accessories.

PrOdUCt SPeCiFiCatiOnS

Input: 4.8 Amps
No-load Speed: 3600 rpm
Output: 3⁄4-peak hp
Blade Diameter: 7 in (180 mm)
Rating: 120 volts~60 hz AC
Depth of Cut: 1 1⁄4 in (33 mm)

ASSEMBLY

ASSEMBLY AND OPERATION INSTRUCTIONS
COMPLETELY BEFORE CONNECTING THE
Water
Reservoir
FOLLOW ALL OF THE
left Cutting
Table Hinge
SAW TO A POWER SOURCE OR TURNING THE
MOTOR ON.
UnPaCKinG
1. Remove all packing materials from around
your saw.
2. Carefully lift the saw from carton and place
it on a level work surface.
3. Do not discard the packing materials until
you have carefully inspected the saw for loose
or damaged parts.
The following items are included in box with
your tile saw: 7 in diamond blade, blade
Guard, rip Guide, Angle Gauge, universal
Wrench and owner's manual
4. Inspect the saw carefully to make sure that
no breakage or damage has occurred during
shipping. If any parts are damaged or missing
return the saw to your place of purchase.
DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
– 5 –
Blade Guard
Right Cutting
Table
Bottom
Storage Area
IF ANY PARTS ARE