Installing The Base - OZ Lifting Products COMPOZITE OZ1200DAV Manual Del Operador

Crane Pre-Installation
Check for damage during shipment. Do not install or use a damaged product. Be sure to maintain records
®
of product information and contact your OZ Lifting Products LLC dealer with any problems that arise.
Refer to applicable codes and regulations before installing equipment. Contact a qualified professional to
obtain structure and foundation specifications for product mounting.
Before installing, select a location where the crane is:
• Visible throughout its entire operation.
• Free of traffic and any possible operational interference.
• Positioned so the operator is clear of both the load and the path of the wire rope.
• Accessible for maintenance.
• Attached to a strong, level foundation that can properly support it under all conditions.
• Removed from any corrosive, flammable, explosive, or potentially damaging materials.

Installing the Base

NOTE: The accompanying base for the CompOZite Davit Crane is sold separately through OZ Lifting
®
Products LLC dealers. It is necessary for proper operation of this product.
The base must be securely fastened to the foundation using 5/8-inch coarse thread fasteners of at least
grade 5. A torque of 150 ft/lb should be used for grade 5 fasteners without lubrication.
Assure that mounting surface is located directly above a strong, level, solid foundation that supports the
crane under all circumstances.
Non-standard products that have been altered from the original design may require alternative fastening
®
requirements. Contact your OZ Lifting Products LLC dealer for more information
EN pg.6