Turntable Panel; Unpacking And Setup - 1 BY ONE 471NA-0002 Manual De Instrucciones

EN
5. STANDBY/ON INDICATOR
DE
7. USB SOCKET
9. BT INDICATOR
FR
11. STANDBY/ON BUTTON
13. BUTTON
ES
15. BT BUTTON
17. BUTTON
JP
IT

TURNTABLE PANEL

1
2
3
1. 45 RPM ADAPTER
3. CONTROL PANEL
5. LIFT LEVER
7. TONE ARM LOCK
9. VOLUME DIAL
6. USB PLAYER INDICATOR
8. PHONO PLAYER/REC INDICATOR
10. USB-MP3 PLAYER BUTTON
12. PHONO-REC BUTTON
14. PHONO PLAYER BUTTON
16. BUTTON
4
5
6
10
7
8
9
2. TURNTABLE
4. TRANSIT SCREW CROSSING
6. SPEED SELECTOR(33/45/78 RPM)
8. TONE ARM WITH STYLUS
10. AUTO STOP CONTROL SWITCH
02

UNPACKING AND SETUP

1. Carefully remove the turntable from the display package and remove all packing
material.
2. Unwind the AC adapter power cord and extend it to its full length.
3. Place the turntable on a stable, level surface in proximity to an AC outlet and
away from any strong magnetic fields.
4. Plug the power cord into your AC outlet.
5. Remove the opaque white plastic stylus cover from the phonograph stylus by
sliding it in the direction of the arrow.
6. Be cautious and gentle when removing this stylus cover, as damage to the stylus
is not covered by warranty.
7. Remove the twist-tie securing the tone arm during the shipment.
8. Release the tone arm lever lock.
POWERING ON THE UNIT
1. Connect the AC Adapter to the AC POWER Socket on the back of the turntable.
2. Press the STANDBY/ON button , the STANDBY/ON indicator will turn off and PHONO
mode will power on.
3. When you have finished using the turntable, press the STANDBY/ON button again
and the voice message "POWER OFF" will confirm the turntable is off.
NOTE
The turntable will automatically turn off without further instruction or signal for 15
minutes.
03
EN
DE
FR
ES
JP
IT