DeVilbiss FLG4-488-K Manual De Servicio página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
TROUBLESHOOTING (Continued)
CONDITION
Runs and sags
Thin, sandy coarse finish drying
before it flows out
Thick, dimpled finish "orange
peel"
ACCESSORIES
HAF-507
Whirlwind™ In-Line Air Filter
Removes water, oil, and debris from the air line.
WR-103 Wrench
Contains all necessary
tip, hose and nut sizes
used on or with gun.
Automotive Quick Connects
For HVLP Guns (Air)
High Flow Type.
HC-4419 Stem
HC-4719 Coupler
1/4" NPT(F)
1/4" NPT(M) /NPS(M)
HC-1166 Stem
HC-4720 Coupler
1/4" NPT(M)
www.carlisleft.com
CAUSE
Too much material flow.
Material too thin.
Gun tilted on an angle, or gun motion too
slow.
Gun too far from surface.
Too much air pressure.
Improper thinner being used.
Gun too close to surface.
Too much material coarsely atomized.
Air pressure too low.
Improper thinner being used.
Material not properly mixed.
Surface rough, oily, dirty.
HARG-510 Air Regulator
Use to maintain nearly constant outlet
pressure despite changes in inlet pres-
sure and downstream flow.
Twin Cartridge,
Paint Spray
Respirator
NIOSH-Certified (TC84A-1623) for
respiratory protection in atmospheres
not immediately dangerous to life.
1/4" NPT(F)
CORRECTION
Adjust gun or reduce fluid flow.
Mix properly or apply light coats.
Hold gun at right angle to work and adapt to proper
gun technique.
Check distance. Normally approximately 8".
Reduce air pressure and check spray pattern.
Follow paint manufacturer's mixing instructions.
Check distance. Normally approximately 8".
Follow paint manufacturer's mixing instructions.
Increase air pressure or reduce fluid flow.
Follow paint manufacturer's mixing instructions.
Follow paint manufacturer's mixing instructions.
Properly clean and prepare.
Spray Gun Lube
SSL-10 (2 oz. bottle)
Compatible with all
paint materials; con-
tains no silicone or
petroleum distillates
to contaminate paint.
SDS Sheet available
upon request.
40-128
Contains six precision tools designed to
effectively clean all DeVilbiss, Binks, Finishline
and other brand spray guns.
Hand Cleaner Towels
Scrubs
hand cleaner towel for painters,
body men and mechanics that
go where you go and no water
is needed.
6 / 6
Air Adjusting Valves
HAV-500 No Gauge
HAV-512 w/0-100 psi
Dial Gauge
HAV-555 w/0-160 psi
Digital Gauge
Use to control air usage
at gun.
192212 Professional Spray Gun
Cleaning Kit
192218 Scrubs
®
®
are a premoistened
SB-2-784-D (1/2018)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Finishline flg4Finishline flg4-488-k

Tabla de contenido