Features; Unpacking And Assembly; Unpacking; Operation Instructions - Urrea FOY HL300 Manual De Usuario Y Garantía

ing arts or converting the machine to another
function. The machine must be attended dur-
ing operation.
- The electric supply to this appliance should in-
clude either a residual current device that will
interrupt the supply if the leakage current to
earth exceeds 30mA for 30ms or a device that
will prove the earth circuit. (Only for recom-
mend)

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. HANDLE.
2. GUN & LANCE
HOLDER.
3. HOSE AND
CABLE HOLDER.
4. WATER OUTLET.
5. GUN.
6. LANCE.
7. LANCE EXTEN-
SION.
8. HOSE.
9. SOAP DEPOSIT.
7
6
8

UNPACKING AND ASSEMBLY

UNPACKING

Remove the machine from the carton and
examine it carefully. Do not discard carton or
any packaging material until all parts are ex-
amined. The packaging is easily recyclable, and
must be disposed of in compliance with the
regulations in force in the country of installa-
tion.
ASSEMBLY
After opening the carton, please remove all
parts and check them against the following list
of components that are included:
1
2
4
5
9
E N G L I S H •
• High pressure washer.
• Adjustable nozzle.
• Gun.
• Water intake filter (Pre-Installed).
• High pressure hose.
To assemble the enclosed parts, please refer to
the steps that follow:
Step 1: Attach the
high pressure
to the gun. Use a
wrench(not include)
to tighten the fitting.
Step 2: Insert the adjustable spray nozzle into
the gun.
Push and turn the
adjustable
clock-wise onto the
3 gun until hand tight
to lock it in place.
When the pieces are joined properly, you can-
not separate the two components by pulling
straight out on the adjustable nozzle. All at-
tachments must be inserted into the gun for
proper use.
Step 3: Attach the high-pressure hose to the
male fitting on the left of the pressure washer.
Before attaching the high-pressure hose to the
male fitting, remove the plastic cap, which is
inserted onto the fitting before shipping. This
plastic cap can be discarded once removed.
Twist on tight to avoid leakage.
Step 4: Attach the garden hose to pressure
washer. Before attaching the nipple to the
male fitting, remove the plastic cap, which is
inserted onto the male fitting on the pressure
washer before shipping. This plastic cap can
be discarded once removed. After both com-
ponents have been installed, attach the gar-
den hose with quick coupler attached to the
pressure washer by pulling back on the sleeve
and inserting the garden hose fitting onto the
nipple fitting installed on the pressure washer.
The components will lock together when fully
inserted. Connect the garden hose to the wa-
ter spout.

OPERATION INSTRUCTIONS

IMPORTANT SAFETY TIPS
• Never point the high-pressure nozzle at peo-
ple or animals.
U se r 's m a nu a l
hose
nozzle
13