Albatross Alba-Engine NMEA2000 Manual De Usuario página 23

3.4.1.3 Choice of parameters to be measured
On inputs 2, 3, 4 and 5 the user can choose what parameters to represent on the digital display.
The available parameters are:
Boost pressure
Oil pressure
Coolant water pressure
Oil temperature
Coolant water temperature
Figure 21. Detail of the configuration of parameters to be measured by the module.
Make sure the signal cable for each chosen parameter corresponds to the connector number from
the following table:
Configtool input
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Table 4. Alba-engine inputs and connector number correspondence
Parameter
RPM
Pressure or Temperature
Pressure or Temperature
Pressure or Temperature
Pressure or Temperature
Alternator voltage
23
Alba-Engine connector
number
Connectors 1 and 2
Connector 4
Connector 6
Connector 8
Connector 10
Connector 12