Custom Sensor Calibration - Albatross Alba-Engine NMEA2000 Manual De Usuario

3.4.2.2 Voltage correction enabled?
If you connected the Alba-Engine in parallel with VDO gauges, you'll have to note the tension at
which the configuration is being set in this field (see the initial screen of Installtool, Figure 4) and
check the toggle box marked "enabled". You'll also have to enter the voltage value at which the
measurement was made (in figure 23, the example is 12,29 V)
Reference voltage
By checking this field, you'll tell Alba-Engine that the voltage your ship works on may change during
its functioning, and this will allow you to adjust the gauges' readings for maximum accuracy at any
time.

3.4.3 Custom sensor calibration

Sensors connected to the Alba- Engine module may need calibration for any of the following
reasons:
1 – A resistive or non-standard tension sensor is being used
2 – A standard sensor is in use, but maximum accuracy is desired.
Annex 1 to this handbook shows you an in-depth explanation of this process.
26