Measuring Procedure; Temperature Alarm - TFA Dostmann KÜCHEN-CHEF Instrucciones De Uso

TFA_No. 14.1510_Anleitung 05.10.2017
Küchen-Chef – Digital BBQ meat thermometer
• Confirm the setting with the ON/OFF button.
• Set the minutes in the same way.
• Confirm the setting with the ON/OFF button.
• The current temperature and the target temperature (70°C default) appear on the display. The alarm is activated.
• The device is ready for use.
7. Operation
• Press ON/OFF button to switch the instrument on or off.
• Press and hold the ALARM button to change between °C (Celsius) or °F (Fahrenheit) as temperature unit. If you set
Fahrenheit as temperature unit the time will be shown automatically in 12 hours system.
• Press the LIGHT button. The backlight is activated briefly.
• Each button operation is acknowledged with a beep.
• Press and hold the + or – button for fast mode.
• Press and hold the ON/OFF button in normal mode for three seconds, to enter the time setting mode.

7.1 Measuring procedure

• For measuring the core temperature of meat: Plunge the probe at least 2,5 cm into the middle of the thickest part of the
meat; for poultry, between the torso and the thigh - it should not touch bones or cartilage and it should not protrude from
the meat. Put the meat into the oven and set the relevant oven temperature. The probe should remain in the meat
throughout the cooking process.
18
11:07 Uhr Seite 10
Küchen-Chef – Digital BBQ meat thermometer
• If you want to measure the cooking chamber temperature, place the probe in the grill or oven. Do not place the probe
directly on the rack. For an optimal measuring result we recommend the clip for BBQ meat thermometer (Cat. No.
30.3525.60) to attach the temperature probe to the grill.
• Simply run the cable to the outside. The cable adapts to the oven seal. Be careful with sharp-edged frames and hinges.
• Place the thermometer securely near the oven (cable length approx. 120 cm). You can either attach the device onto a
metal surface with its magnet or use the fold-out stand to place it onto a flat surface or to hang it.

7.2 Temperature alarm

• Press the ALARM button to activate or deactivate the alarm function. The alarm symbol appears/disappears on the dis-
play.
• Press the + or – button to set the desired core temperature.
• When the target temperature is reached, an alarm tone will sound.
• The backlight turns on.
• Press any button to stop the alarm sound.
• The alarm symbol will continue flashing until the measured temperature is below the desired temperature.
• The alarm sound automatically turns off after 3 minutes if not stopped manually.
8. Care and maintenance
• Clean the instrument and the probe with a soft damp cloth. Do not use solvents or scouring agents. Protect it from mois-
ture.
19