Functional Description And Operation - QEP 830Z Manual De Operación

W W h h i i l l e e u u s s i i n n g g t t h h e e s s a a w w : :
1. Never use-cracked diamond blades, replace them.
2. Be sure that the switch is in the OFF (O)-position before connecting the saw to the main voltage.
3. Always keep away the main lead from moving parts of the saw.
4. Do not apply side-pressure to the diamond blade. It can break the blade and cause harm.
5. Remove the plug out of the wall socket before you make any repairs or replace blade.
I I M M M M E E D D I I A A T T E E L L Y Y S S W W I I T T C C H H O O F F F F T T H H E E S S A A W W I I N N C C A A S S E E O O F F : :
1. Excessive sparking of the brushes.
2. Malfunction of the main plug, socket or damaged cables.
3. Broken switch.
4. Smoke or smell caused by scorched insulation.

FUNCTIONAL DESCRIPTION AND OPERATION

S S T T A A R R T T I I N N G G A A N N D D S S T T O O P P P P I I N N G G
1. Connect the unit to a power supply of the correct
voltage and frequency (120V-60HZ).
2. To start the machine, push the switch "ON" position.
3. To stop the machine, push the switch "OFF" position.
(Fig. 3).
WARNING!
NOTE: REMOVE KEY WHEN NOT IN USE - THIS FEATURE IS
INTENDED TO HELP PREVENT UNAUTHORIZED AND POSSIBLE
HAZARDOUS USE BY CHILDREN AND OTHERS.
WARNING: For your own safety, always push the switch OFF when
the tool is not in use. Remove key and keep it in a safe place. In the
event of a power failure or blown fuse or tripped circuit breaker,
turn switch off and remove the key. This will prevent the saw from
starting up on its own when the power is restored.
Overload Protection: The motor is equipped with circuit breaker. If
the motor is over loaded, gets too hot or the current increases
drastically, the circuit breaker will cut off automatically. If this
happens please wait a few minutes until the motor has cooled down
and then press the reset button (beside the On-/Off-Switch) to reset
the saw.
A A S S S S E E M M B B L L Y Y
R R e e a a d d t t h h e e m m a a n n u u a a l l c c a a r r e e f f u u l l l l y y b b e e f f o o r r e e a a s s s s e e m m b b l l y y . .
1. Clean the working area.
2. Open the package and remove all packing materials,
you will find the folded machine.(Fig. 4)
3. Lay the machine on level surface, pull out the locking
knob (Fig. 5), located under the end of the table to
release the stand on one side (Fig. 6). Make sure the
post and butterfly knob are positioned in groove and
then tighten. (Fig. 7 and 8).
4. Follow the same procedure to unfold the other set of
legs so the saw is upright and locked in position.
5. Adjust the balance knob on one leg (Fig. 9), to stabilize
saw on uneven surfaces.
- 6 -
F F i i g g u u r r e e 3 3
F F i i g g u u r r e e 5 5
F F i i g g u u r r e e 7 7
F F i i g g u u r r e e 4 4
F F i i g g u u r r e e 6 6
F F i i g g u u r r e e 8 8