Extension Cords; California Proposition 65; Description - QEP 22500Q Instrucciones De Funcionamiento

Ampere rating
More than No more than
0
6
10
12
TAbLE 1

EXTENSION CORDS

1. Use only extension cords that are intended
for outdoor use. These extension cords are
identified by a marking "Acceptable for use
with outdoor appliances: store indoors while
not in use." Use only extension cords having
an electrical rating not less than the rating of
the product. Do not use damaged extension
cords. Examine extension cord before using
and replace if damaged. Do not abuse
extension cords and do not yank on any cord
to disconnect. Keep cord away from heat and
sharp edges. Always disconnect the extension
cord from the receptacle before disconnecting
the product from the extension cord.
OF ELECTROCUTION, kEEP ALL CONNECTIONS
DRY AND OFF THE GROUND. DO NOT TOUCH
PLUG WITH WET HANDS.
2. Ground Fault circuit Interrupter (GFCI)
protection should be provided on the circuit(s)
or outlet(s) to be used for the tile saw.
Receptacles are available having built-in GFCI
protection and may be used for this measure
of safety.
3. uSE propEr EXTEnSIon Cord. Make
sure your extension cord is in good condition.
When using an extension cord, be sure to use
a cord heavy enough to carry the current your
product will draw. An undersized cord will
cause a drop in line voltage, resulting in loss
power and overheating. TABlE 1 shows the
correct size to use depending on cord length
and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge
number, the heavier the cord.
noTE: When using an extension cord, ensure
all cords are no smaller than #12 gauge, rated
at a 20-amp minimum, and equipped with
3-prong plugs. Use of anything smaller may
Volts
120 V
240 V
6
10
12
16
TO REDUCE THE RISk
Total length of cord in feet
25 ft. 50 ft.
50 ft. 100 ft.
18 16
18 16
16 16
14 12
result in overheating or burn out of the motor. It
is recommended to have an electrician check
the voltage at the saw motor to ensure proper
voltage to run the saw efficiently and safely.
CALIFORNIA
PROPOSITION 65
BY POWER SANDING, SAWING, GRINDING,
DRILLING AND OTHER CONSTRUCTION
ACTIVITIES CONTAIN CHEMICALS kNOWN
TO THE STATE OF CALIFORNIA TO CAUSE
CANCER, BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.
Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement and
other masonry products
• Arsenic and chromium from chemically-
treated lumber
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specifically
designed to filter out microscopic particles.

DESCRIPTION

Before attempting to use any tool, be sure
to familiarize yourself with all the operating
features and safety instructions.
KnOW yOUr SaW
Your tile saw has many built-in features (see
FIGURE 3) for fast, efficient cutting of ceramic,
marble, slate or limestone wall or floor tile.
– 4 –
100 ft.
200 ft.
AWG
16
14
14
Not recommended
SOME DUST CREATED
150 ft.
300 ft.
14
12
12