Maintenance - QEP 830Z Manual De Operación

2. Lay the machine on level surface, loosen the knobs to
pull out the wheel device (Fig.26).
3. On the opposite side of the where the wheels are
positioned, loosen the knob under saw and pull out the
extending T-handle to the desired length. Tighten the
knob. (Fig27) The T-shaped handle is designed for left
or right-hand users.
4. You are now ready to move the saw. (Fig. 28)
• For short distance moves, the lower wheel system
attached to the legs should be used. Lock wheels to
the down position and lift the machine and pull by the
handle as described below.
1. On the wheels side of the saw, lift the machine and
move the wheels from the inside (Fig. 29) to the out
side (Fig. 30) of the legs, so that the wheels are in
position to roll firmly against the ground.
2. Raise the opposite end with the rubber handle and
move saw to desired location.
Important: When the machine is in use, make sure the wheels are in
the locked-"UP" position (Fig. 31). The saw should stand level when
in use.

MAINTENANCE

While maintaining and cleaning the
CAUTION!
machine, make certain that you unplug the
saw. Never use water or other aggressive liquids while cleaning
electrical parts of the machine.
A. Periodic maintenance of the saw will prevent
unnecessary problems. Use soft cloth to clean the
water and dust on the machine.
B. Keep the ventilation slots of the saw clean to
prevent overheating of the motor.
C. Wipe down and dry the saw as much as possible
after using.
D. Take the two table tops out from the mainframe
and clean the water tray (Fig. 32).
P P U U M M P P M M A A I I N N T T E E N N A A N N C C E E
WARNING!
1. Clean the pump
To clean the pump, remove the intake hose, and
then take out of the filter foam and impeller cover.
(Fig. 33) Use a small brush or stream of water to
remove any debris on the foam and the impeller.
Note: Please clean the pump immediately after using your saw to
prevent dry debris from forming on the filter foam and the impeller,
which will cause early replacement of the filter foam or the pump.
2. Replace the filter foam
To replace the filter foam, remove the intake
cover, remove the foam and replace.
3. Replace the pump
When the pump stops working, first replace the filter
foam. If the pump still does not work, replace problem
pump with a new one. Only use a pump that is
recommended by the manufacturer. The changing
procedures are as follows:
While maintaining and cleaning the
pump, make certain that you unplug
the saw.
F F i i g g u u r r e e 2 2 9 9
F F i i g g u u r r e e 3 3 1 1
F F i i g g u u r r e e 3 3 3 3
Impeller cover
Intake cover
Foam filter
F F i i g g u u r r e e 3 3 5 5
F F i i g g u u r r e e 3 3 7 7
- 9 -
Motor head
F F i i g g u u r r e e 3 3 0 0
F F i i g g u u r r e e 3 3 2 2
F F i i g g u u r r e e 3 3 4 4
F F i i g g u u r r e e 3 3 6 6