Handling The Call Queue - Fermax MDS DIRECT 2532 Manual Del Usuario

Handling the Call Queue

Unanswered calls are stored in the call queue. To answer them, proceed as follows:
A
0001
01
02 0005
03 0012
C
B
NOTE: In day or mixed mode, the last 20 unanswered calls are stored in
the call queue, though only the 10 oldest calls will be shown, grouped
together in the Call Queue.
1.- Pick up the handset.
2.- Press the <A> key to view the call queue on the
screen.
3.- Using the type of queue selection button, select
the type of call you wish to answer (panel or
apartment).
4.- Select the call using the call selection button.
5.- Press the <C> key or the bell button to call the
apartment or establish communication with the
panel (the current communication is registered in
the box at bottom right).
6.- If you need to open the door, press the blue button.
7.- To end the call, press the <B> key or hang up the
handset.
8.- Repeat these steps from point 1 to continue with
the process of answering calls.
Page 9