Temperature Measurement - KPS PF50 Manual De Funcionamiento

KPS-PF50 • Leakage clamp meter
2) Insert the Capacitor under test to the "INPUT" terminal and "COM" terminal.
The measured value will be displayed on the LCD display.
To avoid damage to the meter or to the equipment under test, disconnect power and
discharge all high-voltage capacitors before measuring capacitance.
You can use the DC voltage function to confirm that the capacitor is discharged.

5.9 Temperature measurement

1) Set the rotary switch to the "TEMP" position.
2) In this time, LCD will display the environment temperature.
3) Insert the temperature adapter to the "INPUT" and "COM" terminal , and
then, insert the K-type thermocouple probe to the temperature adapter accord-
ing to its polarity.
4) To change the temperature physical unite( ºC or ºF ) , you can press the
'FUNC' push button.
Note:
- Multi-Function Socket is used as temperature adapter.
- Use K-type thermocouple probe
6. MAINTENANCE
6.1 Replacing the Battery: When meter display low battery indicator(symbol)
on the LCD, you must be replace the battery to maintain normal operation.
(1) Disconnect and remove all test probes from any live source and meter.
(2) Open the battery cover on the bottom case by screwdriver.
(3) Remove old battery and snap new one into the battery holder.
6.2 Fuse replacement: Replacing the defective fuse should done according
to 6.1 section procedure.
6.3 Cleaning and Decontamination:The meter can be cleaned with soft clean
cloth to remove any oil, grease or grim. Do not use the liquid solvent or deter-
gent.
WARNING
17