SURFOX
Smart Passivation Tester
TM
ENGLISH
This manual contains information concerning the proper and safe use of the testing device. The manual
is an integral part of the device and must be kept throughout the entire service life for future consultation.
1. Tool overview
SURFOX™ SMART PASSIVATION TESTER is an electrochemical testing device that provides a digital
value of the quality of the protective chromium passive layer on stainless steel. The device provides
within seconds, a stable and precise value related to the state of the passivation process.
2. Tool features
SURFOX™ SMART PASSIVATION TESTER is built in compliance with established EU
safety standards and bears the CE mark.
FCC
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
Approved
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
FCC ID: PVH0946
IC: 5325-0946
2.1 Components (Fig. 1, page 9)
1.
Bluetooth Unit;
2.
Battery Box (Rear Side);
3.
Test Probe;
4.
Female Connector on test probe;
5.
Male Connector on Bluetooth unit;
6.
Refilling cartridge cap / Cap placement;
2.2 Technical data
MODEL
Supply voltage
Tool weight
Tool dimension (mm)
8
Attention!
Read the instructions carefully before use.
7.
8.
9.
54-T 011
3 x 1.5V (Type N)
300 grams (with batteries)
233 mm x 63 mm x 30 mm (L x W x H)
Testing tip;
Cap;
Ground tip;