Tabla de contenido
Publicidad
6
www.electrolux.com
5. CONTROLS
•
The hood is equipped with buttons
for suction speed control. It is
recommended to turn on the hood a
few minutes before starting to use the
cookers and let it run for about fifteen
minutes after you have finished cooking
in order to eliminate all odors.
•
In case of extreme temperature
changes, the hood will start
automatically due to the existing sensor
and will remain in operation until the
temperature around the hood will
significantly decrease.
•
The control panel of the hood is located
on front of the unit.
1
1
On/Off Button
Pressing this button, the hood is
activated at speed 1.
The hood will turn off when the button is
pressed while in operation.
2
Motor speed
Pressing this button, the hood switches
from off to speed 1.
Pressing subsequently this button more
than once (with the hood in operation),
the motor speed will change:
Speed 1: "1" appears on the display.
Speed 2: "2" appears on the display.
Speed 3: "3" appears on the display.
Intense Speed: "4" flashes on the
display.
Intense Speed has a timer.
Standard duration of the timer is 5 ',
after which the hood passes at speed 2.
To disable this feature before the end
of the preset duration, press button "2"
so that the hood passes to speed 1. By
pressing subsequently button "1", the
hood will be turned off.
3
Light On/Off
4
Button On/Off Sensor
5
Display
2
5
Timer
To activate the speed timer, press
seconds.
After the time indicated according to the
chosen speed, the hood is off.
The timer operates in the following manner:
•
Speed 1: 20 minutes (the display
shows "1" and a flashing dot).
•
Speed 2: 15 minutes (the display
shows "2" and a flashing dot).
•
Speed 3: Display 10 minutes (the
display shows "3" and a flashing dot).
•
Intense Speed: 5 minutes (the display
shows "4" and a flashing dot).
During operation of the hood with the timer,
if you press
press
med speed and if you press button
hood switches to Sensor .
Saturation indicator of the grease filter
After 80 hours of operation, the display
shows alternately the set speed and the
3
4
letter "1".
Saturation indicator of the charcoal filter
After 320 hours of operation, the display
shows alternately the set speed and the
letter "2".
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button 1 for about 3 seconds.
Perform filter maintenance as
recommended in this manual.
In the event that both indicators of filter
saturation "1" and "2" start flashing,
proceed with the reset twice.
The saturation indicator of the charcoal
filter is not normally active and if the hood
is used in the recirculation mode, it must be
activated manually the first time.
Activation of the charcoal filter
saturation indicator:
Turn off the hood and simultaneously press
buttons 2 and 3 for 3 seconds.
The letters "1" and "2" will flash on the
display for 2 seconds, to indicate successful
activation of the saturation indicator of the
charcoal filter.
"1"
the hood turns off, if you
"2"
the hood passes at the program-
"2"
for 2
"4"
the
Publicidad
Tabla de contenido
