Cleaning And Maintenance - ECG VT 3220 2in1 Manual De Instrucciones

CLEANING AND MAINTENANCE

Replacement and cleaning filter and dust container
To make sure that the vacuum cleaner always delivers optimum performance, empty the dust container after
each use and clean the filter.
1. Remove the hand-held vacuum cleaner from the holder in the floor vacuum cleaner.
2. Press the dust container release button and remove the container.
3. Remove the dust container filter.
4. Empty the container.
5. Remove the filter cover 0. Remove the Hepa filter and conical microfilter; clean both filters. You can rinse
both filters in cold water and allow the filters to dry thoroughly before reinserting them into the dust
container. Do not wash the dust container filter in the washer. For drying, do not use a hair dryer, allow
the filter let to dry by itself.
Replace the filter carefully in the dust container. NEVER use the vacuum cleaner without inserted filter.
6.
7. Insert the dust container in the handheld vacuum cleaner.
ATTENTION: The suction opening must be permeable and free of obstructions in all circumstances.
Otherwise, it could lead to engine overheating and damage to the appliance.
Note: Depending on the intensity of use, it is recommended that you replace the filter with a new one
every 3 to 6 months to ensure the top performance of the appliance.
Pulling out and refreshing the
filter
Open the dust container lid by turning
it counterclockwise. Remove the foam
inlet filter from the top of the dust
container. Rinse the filter together with
the holder and allow it to dry naturally
before putting it back into the vacuum
cleaner.
Note: The dust container cannot be
washed with water as it contains
conductive parts.
Dust container assembly
1. Insert the assembled filter into the
dust container by aligning the three
position marks on the filter and
the dust container. The foam filter
belongs on the top.
8
Locked
HEPA filter
Filter
Unlocked
Outer seal Inside seal