Time Setting - TFA Dostmann LOGO Manual De Instrucciones

To alternate between the two times display mode, simply press the "RESET/+/MIN/MAX" button.
3.
When the desired time display is selected, press the "SET/CHANNEL" button once more to enter the
4.
Time setting mode.
Note: When the time display is set as 12-hour mode, the temperature unit will be set to F; when the
time mode is in 24-hour format, the temperature unit will be set to C.

TIME SETTING:

Following from the 12 or 24 hour setting mode.
1. The hour digit in the time section starts flashing
Using the "RESET/+/MIN/MAX" button, enter the hours of the current time and then followed by
2.
pressing the "SET/CHANNEL" button to move into the minutes mode
Again, using the "RESET/+/MIN/MAX" button, enter the minutes of the current time (by holding the
3.
button down, the digits are incremented in steps of five) and then finally followed by pressing the
"SET/CHANNEL" button to exit the setting mode. Your temperature Station is now fully operational.
MINIMUM AND MAXIMUM INDOOR AND OUTDOOR TEMPERATURE READING:
By pressing the "RESET/+/MIN/MAX" button the current indoor and outdoor temperature will alternate
between the minimum, maximum and current temperature recordings. Once a new indoor and/or outdoor
temperature high or is low reached, it will automatically be set into the temperature station's memory.
RESETTING THE MINIMUM AND MAXIMUM TEMPERATURE RECORDING:
By pressing and holding down the "RESET/+/MIN/MAX" button for about 3 seconds, both the indoor and
outdoor minimum and maximum temperature recordings will be reset to the current indoor and outdoor
temperatures. Only the outdoor temperature of the displayed transmitter will be reset. To reset the outdoor
temperature of another transmitter move to the desired channel number.
25