Appendix A - Matsushita SR-8587-B Manual De Instrucciones

APPENDIX A.

Easy Installation of the Device Driver for DOS / Windows 3.1
The SR-8587-B/C DVD-ROM drive must be installed into your host computer, before installing
this device driver.
1. Turn the power of your personal computer on. If your system automatically loads Windows,
you must exit Windows and reach the DOS prompt C:\ .
This explanation assumes that your floppy drive is designed "A" and your hard disk drive "C".
If, however, you have used other letters to designate your drives, please substitute the
appropriate letters.
2. Insert the floppy disk "Device Driver for DVD-ROM drive" into your floppy disk drive.
3. Type A: and press <Enter>.
The current drive changes to "A".
4. Type INSTALL and press <Enter>.
5. Type " 2 " and press <Enter> for selection of Installation menu.
The software will then be transferred, and the CONFIG.SYS, and AUTOEXEC.BAT, etc. will
be changed.
Note: If you want to designate the drive / directory where to install, select "1" of Installation
menu.
6. After you check MSCDEX for use, type " Y " and press <Enter>.
The completion message appears, and reach the DOS prompt.
7. Eject the floppy disk from the floppy disk drive.
After the installation, keep this floppy disk for future use.
8. To restart the system, press the reset button on your personal computer, or the following
keys:
Check that the device driver of this equipment has been installed during the start-up
procedure.
Every time DOS is started, the device driver of this equipment will be automatically installed.
A-12
Installation menu
1. Custom Installation
2. Express Installation.
3. Quit
Please input number ->
Now. in installation point drive C,
MSCDEX in seaching ...
MSCDEX is found in the directory as
follow.
C:\DOS\MSCDEX.EXE
Is this MSCDEX installed on the
system ? [Y/N]
Ctrl + Alt + Delete