Comeg SOPRO 184 Manual De Usuario página 25

Electromagnetic
14
compatibility
Manufacturer's guide and declaration – electromagnetic immunity
The equipment «mono ccd camera» is designed to be used in the electromagnetic environment
specifi ed below. The user should make sure that it is used in this environment.
Immunity test
RF conducted
IEC 61000-4-6
RF radiated
IEC 61000-4-3
Note 1: At 80 MHz and 800 MHz, the higher frequency band applies.
Note 2: These recommendations may not apply in all situations. The propagation of electromagnetic waves is aff ected by
absorption and refl ection due to structures, objects and people.
a The fi eld levels of fi xed transmitters, such as the base stations of radio telephones (cell phones/cordless phones) and ground
mobile radios, amateur radio, and TV, AM and FM radio communication, cannot accurately be assessed theoretically. To obtain
the electromagnetic environment appropriate for fi xed RF transmitters, site measurements must be carried out. If a fi eld
level measured in the operating environment for the "CCD mono video camera" reference equipment exceeds the applicable
compliance levels above, then the proper functioning of the "CCD mono video camera" reference equipment must be checked.
If abnormal functioning is noted, additional measures must be taken, such as reorienting or relocating the reference equipment.
b Above and beyond the 150 kHz to 80 MHz frequency band, the fi eld level must be lower than 3 V/m.
011546C
IEC 60601 Compliance
Level of gravity level
3 Vrms 3 V
150 kHz
at 80 MHz
3 V/m
3 V/m
80 MHz
at 2.5 GHz
Electromagnetic environment - guide
Mobile and portable RF communication
equipment must not be used at a distance
from the "CCD mono video camera"
reference equipment (including the
cables) that is less than the recommended
separation distance, calculated utilising
the formulas applicable depending on the
transmitter's frequency.
Recommended separation distance
d = 1,16 √ P
d = 1,16 √ P 80 MHz to 800 MHz
d = 2,33 √ P 800 MHz to 2.5 GHz
where P is the maximum output power
of the transmitter in Watts (W) assigned
by the manufacturer of the transmitter
and d is the recommended separation
distance in metres (m). The fi eld levels
emitted by fi xed RF transmitters, which
are determined by an electromagnetic
measurement of the site, must be lower
than the compliance level in each
frequency band. Disturbances may occur
in the vicinity of devices featuring the
following symbol:
25