Use; Prerequisites For Use; Preparation For Use - Dräger HPS 7000 Instrucciones De Uso

Use

Marking Explanation of the marking
1 Optical class 1
2-4 Protective filter against ultraviolet light
4-4 Protective filter against infrared light
4 Welding protection filter
4 Use
4.1

Prerequisites for use

The visor must be selected and approved for the intended
application.
4.2

Preparation for use

To make sure the fire helmet fits correctly, the following items
must be adjusted properly:
Wearing height (see Section 4.2.1 on Page 18)

Harness (see Section 4.2.2 on Page 18)

Support ring (see Section 4.2.3 on Page 18)

If the helmet is used as part of a mask/helmet combination, the
mask pockets of the mask/helmet adapter must be adjusted as
well (see Section 4.2.7 on Page 19). In this case, Dräger
recommends a specific donning sequence to ensure the full
face mask and fire helmet are correctly coordinated and fit
properly (see Section 4.3 on Page 19).
WARNING
!
Risk of injury!
The protective effect of the fire helmet is achieved only
when the fire helmet fits perfectly, wearing height,
harness and support ring are properly adjusted and the
chin strap is closed. Only wear the fire helmet when it
is fully assembled. All attachments must be properly
secured to the fire helmet.
NOTICE
i
i
A special narrow strip of protective film is attached to
the lower exterior section of face protector R79292.
This prevents damage to the gold coating. Do not
remove this strip of protective film.
The following preparatory work is optional and are therefore
described in the Technical manual:
Attaching reflective strips

Attaching customised labels

Attaching the lamp holder

Mounting the mounting plate of helmet lamp HPS7000

Changing the position of the eye protector/spectacles

4.2.1 Adjusting the helmet wearing height
Loosen or tighten the hook-and-loop fastener with the red

marking.
NOTICE
i i
Adjust the comfort net to make sure the edge of the
open visor does not block the field of view.
18
4.2.2 Adjusting the harness (head strap)
1. Don the fire helmet and close the chin strap.
2. Adjust the length of the neck strap with the buckles until
both neck straps fit snugly.
3. Adjust the chin strap length until the chin strap rests
properly under the chin. Close the hook-and-loop fastener.
NOTICE
i i
Adjust the harness so that the padding does not cover
the ears.
4.2.3 Adjusting the support ring
1. If necessary, insert the
padding strips into the
support ring and attach the
sweatband to the support
ring as well.
2. Don the fire helmet and
close the chin strap.
3. Push down on
adjusting wheel and turn it
until the support ring fits
snugly against your head.
4.2.4 Adjusting the mask pockets of the mask/helmet
adapter
1. Pull the locking pin out of
the mask pocket (1).
2. Pull the mask pocket back
(2) and remove it from the
lock.
3. Place the mask pocket at
the desired position in the
lock. The position must be
chosen carefully to ensure
the full mask fits tightly on
the face.
4. Insert the locking pin into the mask pocket.
NOTICE
i
i
The mask pockets can be used in 4 positions. Place
both mask pockets at the same position to ensure that
the full-face mask sits evenly on the face.
4.2.5 Attaching the neck guard
Fasten the neck guard to

the 4 push buttons on the
inside of the neck guard
holder.
the
1
2
Dräger HPS 7000
01621991.eps
00621991.eps
00721991.eps