Bosch MUZ9PP1 Instrucciones De Uso página 9

Use
W Risk of injury!
– Do not insert the mains plug until
all preparations for working with the
appliance are complete.
– For safety reasons always fit the
protective drive covers on the front and
rear drive.
– While working, do not reach in between
the rollers and do not insert any objects
between the rollers.
– Do not wear your hair loose or loose-
fitting garments.
Caution!
Never apply pressure to the attachments
when fitting or during use! The bevel gear
and base unit might become damaged.
Recommended speeds
5 for sheets of dough
7 for wide pasta strips
Not suitable for use with this
r
accessory!
z
Making sheets of dough
X Image sequence C
Important: Only prepare the base unit as
described in the main operating instructions.
1. Place the bevel gear on the main drive
with the locking lever open as shown.
Note: The bevel gear can also be fitted
rotated through 180° if you wish to work on
the left-hand side of the appliance.
2. Rotate the bevel gear in a clockwise
direction until it is securely fitted to the
main drive. Fully close the locking lever
to fix the bevel gear in position.
3. Position the pasta attachment for sheets
of dough on the drive of the bevel gear,
holding it at an angle.
4. Rotate the attachment in an
anticlockwise direction until it audibly
clicks into place.
Caution!
It should not be possible to turn the
attachment any further.
5. Pull the control knob out.
6. Rotate the control knob to dough
thickness 8 and let it click into place
again.
7. Plug the mains plug into the mains. Turn
the rotary switch to the recommended
setting.
8. Feed the dough into the attachment
from above, passing all pieces through
the rollers once.
Note: If the dough sticks to the rollers,
leave it to dry for approx. 15-30 minutes.
You can then continue processing the
dough.
9. Now reduce the thickness from position
8 step by step.
10. After each new setting pass the pieces
of dough through the rollers until the
required thickness is reached.
11. Once you have finished work, move the
rotary knob to y. Wait until the drive
comes to a standstill. Disconnect the
mains plug.
12. Hold down the release button and rotate
the attachment in a clockwise direction
until it disengages.
13. Remove the attachment.
Note: Possibly continue work using the
pasta attachment for tagliatelle. X "Making
pasta" see page 10
14. After finishing work:
Open the locking lever on the bevel
gear. Rotate the bevel gear in an
anticlockwise direction and remove.
■ Clean all parts directly after use.
X "Cleaning and maintenance" see
page 10
Please note:
– If you are making sheets for lasagne,
cut the dough into pieces of the required
size and either use immediately or allow
the pieces to dry.
– The sheets of dough can also be
processed further to make ravioli and
many other pasta dishes.
Use en
9