Dexter CDT112 LD.T Manual Del Usuario página 91

OPERATING INSTRUCTIONS
1. HOW TO USE THE BELT CLIP (SEE FIG.B1, B2)
Screw the Belt clip (5) on the tool with the screw provided in the plastic bag. The Belt clip can be
hooked on your belt or pocket, etc.
2. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release it to stop your drill. The on/off switch is fitted with a
brake function which stops your chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of switch trigger depression.
WARNING: Do not operate for long periods at low speed because excess heat will be
produced internally.
3. SWITCH LOCK
The switch trigger can be locked in the OFF position. This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger, place the rotation control in the center position.
4. REVERSIBLE (SEE FIG. D1, D2)
For drilling and screw driving use forward rotation marked "
use reverse rotation marked "
jammed drill bit.
WARNING: Never change the direction of rotation when the chuck is rotating, wait until it has
stopped!
5. CHUCK ADJUSTMENT (SEE FIG. E1, E2)
To open the chuck jaws rotate the front section of the chuck in direction 1. Insert the drill bit between
the chuck jaws and rotate the front section in the direction 2. Ensure the drill bit is in the center of
the chuck jaws. Finally, firmly rotate the front chuck section in the directions 2. Your drill bit is now
clamped in the chuck.
6. TORQUE ADJUSTMENT (SEE FIG. F)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is less when the torque adjustment ring is set
on a lower setting.
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 18 for driving screws into soft and hard material
for heavy drilling
7.AUTOMATIC SPINDLE LOCK (SEE FIG. G)
The automatic spindle lock allows you to use it as a regular screwdriver. You can give an extra twist
to firmly tighten a screw, loosen a very tight screw or continue working when the battery energy has
expired. For manual screwdriver purposes, the chuck is automatically locked when the tool is off.
8. USING THE SIGHT LIGHT
To turn on the light simply press the on/off switch. When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed area. LED is also a battery capacity
indicator. It will flash when power gets low.
" (lever is moved to the right) to remove screws or release a
" (lever is moved to the left). Only
EN
91