Problem Solution - Dexter CDT112 LD.T Manual Del Usuario

EN
9. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole location. This
will prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and place
the tip of the bit at the point to be drilled. Depress the switch trigger to start the tool. Move the drill
bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force or apply
side pressure to elongate a hole.
Tungsten carbide drill bits should always be used for concrete and masonry. When drilling
in metal, only use HSS drill bits in good condition. Always use a magnetic bit holder (not
included) when using short screwdriver bits. When screw-driving, apply a small quantity of liquid
soap or similar to the screw threads to ease insertion.
10. DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of the battery pack properly. This
battery pack contains Lithium batteries. Consult your local waste authority for information
regarding available recycling and/or disposal options. Discharge your battery pack by
operating your drill, then remove the battery pack from the drill housing and cover the battery pack
connections with heavy-duty adhesive tape to prevent short circuit and energy discharge. Do not
attempt to open or remove any of the components.
11. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the machine immediately and
allow cooling for approx. 30 seconds at the highest no-load speed.
12. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the load is too high
or the allowable battery temperature of 75°C is exceeded, the electronic control switches off the
power tool until the temperature is in the optimum temperature range again.
13. PROTECTION AGAINST DEEP DISCHARGING
The Li-Ion battery is protected against deep discharging by the "Discharging Protection System".
When the battery is empty, the machine is switched off by means of a protective circuit: The inserted
tool no longer rotates.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in the lock function.
Unlock the forward/reverse rotation control by putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you can find the torque-adjusting ring between
the chuck and the drill body. Position 1 is the lowest torque (screw driving force) and position 18
is the highest torque (screw driving force). Position
adjusting ring to a higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, as following: having not used a battery pack for a long time will reduce the
battery pack working time. This can be corrected after several charge and discharge operations by
charging & working with your drill. Heavy working conditions such as large screws into hard wood
will use up the battery pack energy faster than lighter working conditions. Do not re-charge your
battery pack below 0ºC and above 40ºC as this will affect performance.
92
is for drill operation. Regulate the torque