Features; Assembly Instructions; Operating Instructions - DSR Industrial Serie Manual Del Usuario

8.

FEATURES

3
1
9.

ASSEMBLY INSTRUCTIONS

Remove all cord wraps and uncoil the cables prior to using the battery charger.
10.

OPERATING INSTRUCTIONS

assembly instructions before it is used.
Thermal Runaway
As a safety precaution, the charger automatically reduces the current if it detects the
battery may be getting too hot.
Charging
1. Ensure that all of the charger components are in place and in good working
condition.
2. Connect the battery to the charger by connecting the quick-connect connector on the
charger output cable to the quick-connect connector on the battery.
3. Connect the AC power following the precautions listed in section 7.
4. Switch the power switch to the ON position to turn the charger on.
5. To disconnect, reverse the procedure.
Automatic Charging Mode
When an Automatic Charge is performed, the charger switches to the Maintain Mode
(see below) automatically after the battery is charged.
Aborted Charge
If charging cannot be completed normally, charging will abort. When charging aborts, the
charger's output is shut off and the CHARGING (yellow) LED will blink. To reset after an
aborted charge, unplug the charger from the AC outlet, wait a few moments and plug it
back in.
Desulfation Mode
If the battery is left discharged for an extended period of time, it could become sulfated
and not accept a normal charge. If the charger detects a sulfated battery, the charger will
switch to a special mode of operation designed for such batteries. If successful, normal
charging will resume after the battery is desulfated. Desulfation could take 8 to 10 hours.
If desulfation fails, charging will abort and the CHARGING (yellow) LED will blink.
This battery charger must be properly assembled in accordance with the
• 5 •
2
1. ON/OFF Switch
2. Charging/Charged
LED
3. Quick-Connect
Connector