Operation - Ryobi P430 Manual Del Operador

WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Polishing and buffing cars, boats, RVs, personal watercraft,
motorcycles, hardwood floors, and large furniture
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator's
Manuals for your Ryobi One+ battery pack and charger
models.
BATTERY PROTECTION FEATURES
Ryobi lithium-ion batteries are designed with features that
protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
STARTING/STOPPING THE
BUFFER/POLISHER
See Figure 2, page 10.
 To start the buffer/polisher, place the power switch in the
ON ( l ) position.
 To stop the buffer/polisher, place the power switch in
the OFF ( O ) position.

OPERATION

TO INSTALL / REMOVE BATTERY PACK
See Figure 3, page 10.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Place the power switch in the OFF ( O ) position.
 Place the battery pack in the tool.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the tool
before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the slot in the buffer/pol-
isher and latches into place properly. Improper installa-
tion of the battery pack can cause damage to internal
components.
To remove:
 Place the power switch in the OFF ( O ) position.
 Locate latches on side of battery pack and depress both
sides to release battery pack.
 Remove battery pack from the tool.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF ( O ) position when
not in use or carrying at your side.
PREPARE THE SURFACE
For best results, the surface should be clean and dry. Most
high-gloss surfaces can be cleaned with a mild soap and
water solution. For removal of stubborn dirt such as road
tar, grease, and bug stains, you can use a mild ammonia
solution such as that used in glass cleaners. Before using
any cleaning product, check the label for recommended
applications and follow the directions for use.
Never apply cleaner directly onto surface to be polished.
Apply to a clean cloth then use the cloth to clean the surface.
Do not use any type of abrasive cleanser as it may damage
or scratch the surface.
7 – English