Denver ORUS Instrucciones De Uso página 12

ERROR CODE INDICATOR:
When the system fails, the error icon and error code will flicker
at the frequency of 1Hz. Different fault codes represent different
fault Information.
Error codes are defined:
ERROR CODE
0
1
2
3
4
5
6
7
8
9
Only when the fault is excluded, the fault display interface can exit.
6) SET OPERATION:
Press the set key for 3 seconds to enter the set interface in the normal boot mode, and the set icon is in the
state of 1Hz flash.
Press the set button to switch from 0 to 4 cycle settings interface, long press the set key to exit the setup
interface.
In the current settings, press the key "+ "or "-" to select the desired Parameter configuration. Long press the
SET key 1 second to save and exit.
7) DISTANCE INDICATOR.
Total distance (ODO): Total (Km) mileage recording from first riding to the current (Km) mileage, this
parameter in the conventional interface can be cleared by press "+" and "-" in 12s.
Trip distance: Single (Km) mileage, can be cleared by pressing "- " key in SET 1.( More than 500km
automatically cleared).
8) TRIP TIME INDICATOR: This parameter is automatically cleared after shutdown.
9) BATTERY CAPACITY:
The battery consists of five grid, each grid represents 20% of
the electricity, when five are bright, power is full, when the
last grid flashes, the battery is very low, need to be
recharged immediately.
No fault
Current anomaly or MOS tube damage
Grip shifter anomaly (boot detection)
Motor phase failure
Abnormal motor Hall signal
Brake abnormal (boot detection)
Under voltage
Motor stop protection
Controller communication anomaly
Display communication anomaly
DEFINATION
(Fig 6.0)
(Fig 5.7)
11/17