Instructions And Safety; Safety Warnings; Function Description - ALFA force Manual De Instrucciones Y Seguridad

EN

INSTRUCTIONS AND SAFETY

Thank you for choosing this product, which is designed to meet the highest standards of quality
and reliability.
IMPORTANT
READ THIS MANUAL CAREFULLY BEFORE USING
SAVE THIS MANUAL FOR ANY FUTURE REFERENCE
Instructions should be considered as part of the product and must be maintained throughout the
product life cycle.
If the equipment is transferred to another owner, all documentation must be submitted.
For a safe and proper use of the product, the user must carefully read the instructions and
warnings in the manual as they provide important safety information and instructions for use and
maintenance.
In case of loss of the instructions, contact the company at the following address:
Alfa Hogar, S.L.
info@alfahogar.com

SAFETY WARNINGS

1. Before using the product, check that the device is intact without visible damage. If in doubt,
do not use the product and contact your dealer.
2. Keep the plastic bag in the package out of the reach of children: danger of suffocation.
3. Before connecting the product, make sure that the mains voltage data indicated on the sticker
on the bottom of the product corresponds to the power supply.
4. This product should only be used for the purpose for which it was designed and in the manner
indicated in the instructions. Any other use is not compliant and, therefore, is dangerous. The
manufacturer is not liable for damages resulting from incorrect use.
5. This product can be used by children over 14 years of age.
6. The use and maintenance of this appliance may be performed by persons with reduced
physical, sensory or mental capabilities or by inexperienced persons under the special
supervision of an adult. Children should not play with the product.
7. Never leave the product unattended, turn it off after use and unplug it from the mains when
not in use.
8. In case of malfunction, turn off the product without damaging it. For inquiries and repairs,
always contact your dealer.
9. DO NOT plug, unplug or use the product with wet or damp hands or feet.
10. DO NOT pull on the power cord or the unit to disconnect the plug from the power outlet.
11. Treat the product carefully, protecting it from shock, extreme temperature variations,
humidity, dust, sun and heat sources.
12. Disconnect the plug from the outlet immediately after use and always before cleaning.
13. If water falls on the product, do not attempt to take it, but immediately disconnect the plug
from the power outlet.
14. Attention! DO NOT interfere with the power cord for any reason. In the event of any damage,
contact your dealer.
15. Extend the cable over its entire length and keep it away from heat sources.
16. Never use power supply adapters with different electrical requirements from the
identification label attached to the unit.
17. The machine is not protected against penetration of liquids.
18. Do not touch the sealing strip when the product is on: danger of burns.
19. NEVER immerse the product in water or other liquids.
20. Avoid extreme fluctuations in temperature, humidity, dust, sun and heat sources.
ATTENTION! BEFORE USING THIS PRODUCT
• In extreme conditions of use (voltage 10% higher than nominal voltage and temperature
around 40°C) intensive use of the machine could trigger automatic heat protection devices.
In this case, it is necessary to wait until the device cools down before re-use.
• Do not perform more than 10 consecutive vacuum cycles. Beyond this limit, the thermal
protection systems of the device can blow (we recommend waiting at least 60 seconds
between two sealing processes).
• DO NOT store the machine with the handle blocked.
• This product is not suitable for professional use. Only domestic use is recommended.

FUNCTION DESCRIPTION

1. Vac&seal / Cancel: This button has two functions depending on the machine status:
• At stand-by condition, it starts the automatic operation of vacuuming the bag and then
automatically seals the bag when vacuum is complete.
• At working (vacuuming or sealing operations) condition, it stops the machine.
2. Manual Vacuum: Press this button, and the device starts vacuuming. Undo, and it will stop.
6