AERMEC FCL Manual De Uso página 16

TIMER ON
The unit will switch on automatically according to the setting chosen.
Timer duration can be set from a minimum of half an hour (30 minutes) to a maximum of 12 hours.
Up to 9.5 hours, you can set half hour (30 minute) increments; from 10 to 12 hours, 1-hour increments.
Notes
• The display indicates that the
unit has been set to reach the
desired room temperature after
6.5 hours.
NOTES ON TIME SETTING AND OPERATION
• The latest time setting will be memorised and visualised
on the remote control display the next time you set TIMER
OFF or TIMER ON.
• TIMER ON and TIMER OFF cannot be set together.
Only the most recent TIMER setting will be valid.
16
IFCLFJ 1102 - 4528570_02
1
1
Point the remote control towards the unit's signal
receiver window.
Press the TIMER OFF button (
time as desired.
• The time setting will change as you press the button
as follows.
0.5h 1.0h 1.5h
Hold the button down to speed through the settings.
• The yellow TIMER indicator light on the unit will light
up.
• The unit generates a beep when it receives the
signal.
• The time setting will count down to show the
remaining time.
Select the mode, temperature and fan speed setting
as desired.
• When the temperature is set with TIMER ON, the
display will visualise the temperature for 5 seconds
before returning to the time display.
• If you do not change the setting, the unit will
operate using the most recent settings.
• When the ONE-HOUR OFF TIMER is set, the TIMER
OFF and TIMER ON settings are unavailable.
• If the ONE-HOUR OFF TIMER is set when the TIMER
OFF or TIMER ON is activated, the TIMER ON or TIMER
OFF setting will be cancelled.
) and set the
10h 11h 12h