interior
7/6/06
will take place if you have selected 50%,
55%, 60% or 65% humidity.
(7) To switch off the appliance, press the
button. The ambient humidity will
flash on the display.
Caution: If the "Defrost" function appears
when the appliance is switched on and it is
not possible to select another function, switch
the unit off by pressing the on/off button and
unplug the device. Then switch it back on
again.
7. DRAINING OFF THE
CONDENSATION WATER
WATER TANK
If the water tank (4) is full or if it has not been
correctly fitted to the appliance, the "WATER
FULL" indicator will appear on the display
and the dehumidifier will automatically switch
off.
To drain the water tank, remove it from the
appliance as shown in FIG. 3. The water tank
can be lifted up and carried by its handle,
located on the back of the tank. Carefully fit
the water tank to the appliance again, making
sure the "WATER FULL" indicator switches
off.
CONNECTION FOR CONTINUOUS
DRAINAGE
The condensation water can be run off to a
drain outlet down a drain tube connected to
the condensation water outlet. The procedure
for this is as follows:
a. Remove the water tank (FIG. 3)
b. Open the continuous drainage hole (9)
with a sharp object (FIG. 5).
c. Insert the end of the plastic tube through
this hole and adjust it to the condensation
water outlet hole (FIG. 6). Run the other
end of the tube to a drain outlet.
d. Lastly, fit the water tank back into position
(the "WATER FULL" " indicator will switch
off).
11:09
Página 13
8. MAINTENANCE AND CLEANING
Unplug the appliance before carrying out any
maintenance or cleaning.
Clean the outside of the appliance with a soft
damp cloth.
Do not use water, solvents or similar
substances to clean the appliance. Do not
use abrasive cleaning agents.
AIR FILTER (5)
The air filter is located behind the air inlet
grille. It should be cleaned every two weeks.
To clean the filter, proceed as follows:
•
Before removing the filter from its housing,
first drain the water tank (FIG. 3).
•
To remove the filter from its housing, slide
it downwards (FIG. 4).
The dirt accumulated in the filter can be
vacuumed out. If the filter is very dirty, it may
be washed in warm water. Rinse it and wait
until it is completely dry before replacing it in
its housing.
NOTE: do not expose the filter to the sun as
it could warp.
On fitting the new filter, check the arrows are
pointing towards you. Then insert the new
filter and slide it upwards until it correctly fits
into place.
CHARCOAL FILTER (5.3.)
The charcoal filter (included) can be mounted
optionally. If you wish to mount this filter,
follow the instructions shown in FIG.4.
This filter is fitted between the nylon filter
(5.2) and the nylon support (5.1).
Warnings:
1) Take the filter out of its plastic bag before
fitting it.
2) The charcoal filter should be replaced
every 2 months.
3) The charcoal filter is not washable. It
needs to be replaced by a new one.
14