CASUALPLAY newmoon Instrucciones De Uso página 15

• Be very careful when installing the product since correct installation may save your child's life
in the event of an accident (follow the manufacturer's instructions correctly).
• It is important that the other passengers in the vehicle also wear their seat belts, because in
the event of an accident they could get flung about and injure the baby.
• Regularly check the different parts of the carrycot.
• The Newmoon should never be used without the mattress
• Never leave the child unsupervised.
• After placing the child in the carrycot, make sure that the seat belt is tightened correctly.
• Do not replace the mattress with another one that has not been recommended by the
manufacturer as it has a direct influence on the functioning of the restraint system.
• Do not use any mattress that has not been supplied by the manufacturer.
• You are responsible for the child's safety.
Instructions for use
Fitting the hood
• Fit the hood by inserting the guides on both ends into the grooves found on the sides of
the newmoon (fig.1). It will click when correctly fastened.
• To remove the hood, press the front tab on the guide upwards and pull forwards.
• The rear part of the hood zips onto the newmoon.
Fitting the foot cover
• Place the foot cover on the newmoon and fasten it with the zip.
Installing the Newmoon in the vehicle
• Fit the safety anchors into place (fig.2).
NOTE: the open part (red part) of the safety anchors for the belts should be facing the backrest
of the seat.
• Unfasten the side belts of the rear seat of the vehicle (fig.3), and place the carrycot on the
seat (fig.4).
• Pull the diagonal and abdominal parts of the seat belt (fig.5) until obtaining the required
length (fig.6).
• Hold the seat belt by the abdominal section, turn the belt towards the opposite side of the
seat belt buckle forming a loop (fig.7).
13