Product Description; Important Maintenance Information; Packing - AERMEC FCX P Serie Manual De Instrucciones

IT EN FR

PRODUCT DESCRIPTION

• Fan coils Duct installation without cabinet FCX P, PO, PE, Vertical and
horizontal installation
• Fan coils Duct installation without cabinet FCX PV, Vertical installation:
• The FCX P fan coil concentrates high technological and functional
characteristics that make it the ideal climate control unit for all types of rooms.
• The supply of climate controlled air is immediate and distributed throughout
the room; FCX P generates heat if included in a heating system with boiler
or heat pump but may also be used in summer as an air conditioner if the
heating system has a water chiller.
• The response to the controls is immediate.
• The control panel is on the head, it allows changing the fan speed manually
and switching it on-off.
• The panel can be protected against tampering, by locking the cover door
with a screw.
• The FCX P fan coil has been designed to meet all system requirements thanks
to its extensive range of accessories.
• Easy installation with reversible hydraulic connections during installation.
• Full respect for accident prevention regulations.
• Routine maintenance is reduced to periodic air filter cleaning with a vacuum
ATTENTION
Electrical diagrams, installation and operating instructions for accessories and thermostats are supplied
together with the accessory itself. For more information contact Aermec.

IMPORTANT MAINTENANCE INFORMATION

WARNING: The fancoil is connected to the power supply and a water
circuit. Operations performed by persons without the required technical
skills can lead to personal injury to the operator or damage to the unit
and surrounding objects.
POWER THE FANCOIL WITH SINGLE-PHASE 230 V ONLY
• Use of other power supplies could cause permanent damage to the fancoil.
NEVER USE THE FANCOIL FOR APPLICATIONS FOR WHICH IT WAS NOT
DESIGNED
• Do not use the fancoil in husbandry applications (e.g. incubation).
AIR THE ROOM
• Periodically air the room in which the fancoil has been installed; this is
particularly important if the room is occupied by many people, or if gas
appliances or sources of odours are present.
CORRECTLY ADJUST THE TEMPERATURE
• Room temperature should be regulated to ensure maximum comfort to
persons present, particularly in the case of the elderly, infants and invalids.
Prevent temperature fluctuations between indoors and outdoors greater
than 7 °C during summer.
• Note that very low temperatures during summer will lead to greater electricity
consumption.
ORIENT AIR FLOW CORRECTLY
• Air delivered by the fancoil should not be oriented directly at people; even
if air temperature is greater than room temperature, it can cause a cold
sensation and consequently discomfort.
DO NOT USE HOT WATER
• When cleaning the indoor unit, use rags or soft sponges soaked in warm
water (no higher than 40°C).
• Do not use chemical products or solvents to clean any part of the fancoil.
• Do not splash water on interior or exterior surfaces of the fancoil; danger of
short circuit.

PACKING

• The units are shipped in cardboard box standard packing and polystirene
shells.
12
DE ES
cleaner.
• The control panel (accessory) is available only wall-mounted in versions P, PBV,
PBVD, PV, POBV, POBVD, and PO.
• FCXPBV: (wall/ceiling mounted without cabinet) with double circuit coil for
4‐pipe system with standard connections (left)
• FCXPBVD: (wall/ceiling mounted without cabinet) with double circuit coil for
4‐pipe system with right connections
• FCXPOBV: (wall/ceiling mounted without cabinet with powered motor) with
double circuit coil for 4‐pipe system with standard connections (left)
• FCXPOBVD: (wall/ceiling mounted without cabinet with powered motor)
with double circuit coil for 4‐pipe system with right connections
• The hydraulic connections of the BV and BVD versions, up to size 56,
are not reversible during installation. Specify the connection side when
placing the order.
PERIODICALLY CLEAN THE FILTER
• Frequent cleaning of the filter will ensure more efficient unit operation.
• Check whether the filter requires cleaning; if it is particularly dirty, clean it
more often.
• Clean the filter frequently. Use a vacuum cleaner to remove built up dust.
Avoid water or detergents if possible since they greatly accelerate loss of the
filter's electrostatic charge.
• After cleaning and drying the filter, fit it on the fancoil by following the
removal procedure in reverse order.
SPECIAL CLEANING
• The removable drip tray and fan volute ensure thorough cleaning of the
unit (by specifically trained personnel), essential for installations in venues
subject to crowding or in those with special hygiene requirements (chapter
"drawings - Figure 1").
DURING UNIT OPERATION
• Always leave the filter on the fancoil during operation (otherwise dust in the
air could soil the surface of the coil).
IT IS NORMAL
• During cooling, water vapour may be present in the air delivery of the fan coil.
• In the heating function it might be possible to hear a slight hiss around the
fan coil. Sometimes the fan coil might give off unpleasant smells due to the
accumulation of dirt in the air of the environment (especially if the room is not
ventilated regularly, clean the filter more often).
• During the operation, there could be noises and creaks inside the device, due
to the various heat expansions of the elements (plastic and metallic), but this
does not indicate any malfunctioning and does not cause damage to the unit
unless the maximum input water temperature is exceeded.
WARNING
• Avoid that the device is used by children or incompetent persons without
appropriate supervision; also note that the unit should not be used by
children as a game.
FCX P_PO_PV 1605- 6456063_02