Tabla De Contenido; Machine-Related Safety Instructions - Festool Symetric Manual De Instrucciones

Compound mitre saw
SYMMETRIC SYM 70
Table of contents
1 Technical data
2 Graphical symbols
3 Intended use
4 Safety instructions
5 Machine elements
6 Settings
7 Power supply and start-up
8 Operation
9 Service and maintenance
10 Accessories
11 Disposal
1 Technical data
Power
Rotational speed (idle)
Mitre angle
Inner angle
Outer angle
Cutting range
max. workpiece height
max. workpiece width
Saw blade
Weight
Protection class
The specifi ed illustrations are at the beginning of
the Operating Instructions.
2 Graphical symbols
Caution. Danger!
Read the operating instructions/notes
Wear ear protection!
Wear protective goggles!
3 Intended use
The electric power tool is a stationary unit de-
signed for sawing blocks of wood, plastic or
aluminium.
Other materials, in particular steel, concrete and
mineral materials, must not be processed.
Aluminium must only be sawed with the special
saw blades from Festool designed for this pur-
pose.
The electric power tool is designed and approved
for use by trained persons or specialists only.
Other risks
• Workpiece parts being thrown off
• Parts of damaged tools being thrown off
• Noise emission
• Sawdust emission
4
4.1
1150 W
2700 - 5200 rpm ings and instructions may result in electric shock,
fi re and/or serious injury.
0° - 68° Save all warnings and instructions for future
0° - 60° reference.
The term „power tool" in the warnings refers
70 mm to your mains-operated (corded) power tool or
80 mm battery-operated (cordless) power tool.
216 x 2.4 x 30 mm • Never allow children to use the machine.
9.6 kg • Before using the machine, make yourself suf-
/ II
4.2
Safety precautions
• Always use original Festool tools (in accordance
• Use only correctly sharpened tools without dam-
• Select the saw blade suitable for the material
• Do not use saw blades made of high-speed steel.
• Only use spacers and spindle rings specifi ed by
• Ensure the work area has adequate lighting.
• Ensure that the machine is on a firm base.
• Only use the machine if all protection devices
• To minimise the release of dust, the machine
12
The user bears the responsibility for dam-
age and accidents caused by improper
use.
In spite of compliance with all relevant
design regulations, dangers may still
present themselves when the machine
is operated, e.g.:
Safety instructions
General safety instructions
WARNING! Read all safety warnings and
all instructions. Failure to follow the warn-
fi ciently familiar with the application, setting and
operation of the machine.

Machine-related safety instructions

with EN 847-1).
age or deformation. The maximum rotational
speed specifi ed on the tool must be observed.
you wish to work on.
Festool.
Place the machine on a fl at fl oor or secure the
machine fi rmly on a bench or table.
are in their correct positions, the machine is in
good condition and has been well maintained.
should be connected to a suitable extraction
unit. All dust extraction elements (exhaust
hoods etc.) must be properly set.