Placing Requirements For The Machine; Preparation Before Use; Transportation And Installation; Choose A Suitable Place - Auxilab Fugelab-GB10 Manual De Usuario

sudden power failure, trouble when the rotor is rotating or you can't open the door by
pressing keys.

2.4 Placing requirements for the machine

2.4.1 The device should be placed in a horizontal table-board with sufficient rigidity and it
should be far away from any vibration shock device. Keep it away from heat and direct
sunshine.
2.4.2 There should be a space of 10cm to 15cm around the centrifuge for its ventilation.
2.4.3 Adjust it after installation and make the 4 supporting legs of the bottom of the
machine support the machine evenly.
2.4.4 The equipment supply is AC230V 50HZ/60HZ.
3 Preparation before Using
rd

3.1 Transportation and installation

The low-speed centrifuge is transported in a packing container with buffer
protective materials inside. Please remove these buffer materials when you open the
package.
Please use a special packing chest, fix it firmly and keep it vertically for
long-distance transportation. Please handle with care.

3.2 Choose a suitable place

Versión 08 Enero 2018
The machine must be totally grounded and the
power ground lead should be connected to the ground
lead in the electricity grid. Don't cut the electricity when
the rotor is running or it will damage the control circuit.
The net weight of the machine is 15 kg. Please lift
the machine from left and right sides balanced.
Please move it vertically and don't swing it.
Pág. - 33 -