Installation Notes - Waeco PerfectView REC 400 Instrucciones De Montaje

PerfectView REC 400
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating man-
ual.
2.2

Installation notes

!
CAUTION!
Secure the parts installed in the vehicle to prevent them from
becoming loose under any circumstances (sudden braking, ac-
cidents) and causing injuries to vehicle occupants.
Secure any parts of the system concealed by the bodywork in
such a manner that they cannot be come loose or damage other
parts or cables, or impair vehicle functions (steering, pedals,
etc).
Always follow the safety instructions issued by the vehicle man-
ufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.)
may only be performed by qualified specialists.
A NOTICE!
To prevent damage when drilling, make sure there is sufficient
space on the other side for the drill head to emerge.
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
A
NOTICE!
Only use a diode test lamp or voltmeter to test voltages in elec-
tric cables.
Test lamps with a bulb consume too much voltage, which can
damage the vehicle's electronic system.
When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
Insulate all connections.
Secure the cables against mechanical wear by using cable
binders or insulating tape, for example on existing cables.
EN
Safety instructions
29