Installing The Video Recorder - Waeco PerfectView REC 400 Instrucciones De Montaje

PerfectView REC 400
The following indicators and connections are found at the front of the video
recorder:
No. in
fig. 3,
Designation
page 4
1 Green LED
2 Yellow LED
3 Red LED
4 Infrared receiver for remote control
5 Slot for SD card
6

Installing the video recorder

A CAUTION!
Install the device so that it cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause injuries to
the occupants of the vehicle.
Never install the video recorder in areas where your head could
hit it, or in the path of an airbag. This could cause injury if the
airbag opens.
Insulate all connections.
Secure the cables against mechanical wear by using cable
binders or insulating tape, for example on existing cables.
The installation location should be level.
➤ Affix the video recorder to a suitable location in the vehicle (e.g. in the boot
or under the seat).
➤ Affix the video recorder using the four fastening holes.
EN
Installing the video recorder
Description
LED lights up: The video recorder is
switched on
LED does not light up: The video
recorder is switched off
LED lights up: GPS ready
LED does not light up: GPS not ready/
not connected
LED flashes: The video recorder is
recording
LED does not glow: The video recorder
is not recording
LED flashes quickly: The playback
mode is switched on
33