Waeco Refresh-o-mat HD Instrucciones De Uso página 25

Refresh-o-mat HD
Setting the air-conditioning system
➤ Set the air-conditioning system (fig. 8, page 4):
– Set the temperature control to the lowest level (1).
– Set the blower to the lowest level (2).
– Set the front ventilation (3) and open all air outlets on the dashboard
and position upwards.
– Set to ventilation (4).
➤ Manual air-conditioning systems: Switch off the air-conditioning
system (5).
➤ Automatic air-conditioning systems: Set to "Economy" (6) and the lowest
temperature setting.
Starting the cleaning procedure
!
CAUTION! Health hazard!
Do not breathe in the spray.
➤ Press "START/STOP" once (fig. 9, page 4), to start the cleaning proce-
dure with 100 ml of fluid.
✓ The "READY/ON" LED lights up green.
I
NOTE
For a cleaning procedure with 400 ml of fluid, press "START/
STOP" twice. All three LEDs flash briefly to confirm.
➤ Make sure that the spray from the ventilation is sucked up (fig. 0,
page 4).
➤ Get out of the vehicle and close the doors.
➤ Allow the air-circulation/automatic air-conditioning system to run for about
20 minutes.
Ending the cleaning procedure
I
NOTE
The Refresh-o-mat stops automatically when the fluid reaches a
minimum level.
➤ Press "START/STOP" once, to end the cleaning procedure prematurely.
➤ Disconnect from the mains.
EN
Operation
25