Maintenance And Care; Fcc Compliance - Bushnell HOLO Sight 510023 Manual De Instrucciones

MAINTENANCE AND CARE

Your BUSHNELL HOLOsight is a precision instrument that deserves reasonably cautious care. The
following tips are provided to ensure long lasting use of the sight.
1. The optical system and the window are coated with anti-reflection material. When cleaning the
glass surfaces, first blow away any dirt and dust. Fingerprints and lubricants can be wiped off
with lens tissue or a soft cotton cloth, moistened with lens cleaning fluid or glass cleaner sold in
any camera store.
Never clean the glass surface with a dry cloth or paper towel; always dampen the glass surfaces
prior to cleaning.
2. All moving parts of the sight are permanently lubricated. Do not try to lubricate them.
3. No maintenance is needed on the sight's surface, except to occasionally wipe off with a soft damp
cloth. Use only a water-based cleaner such as glass cleaner, ammonia, or soap and water. Never
use any solvent-type cleaner such as alcohol or acetone.
4. Never disassemble the sight's optical assembly. The optical cavity is purged, nitrogen filled, and
sealed to achieve fog proof performance. Disassembly will void the warranty.

FCC COMPLIANCE

The BUSHNELL HOLOsight has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help
Specifications and designs are subject to change without any notice or obligation on the part of the
manufacturer.
6
2008 Holosight 510023+510023AP 6LIM rev3.indd 8
.
2/27/2008 11:07:29 AM