Maintaining Your Tile Saw; Troubleshooting - Skil 3540-02 Instrucciones De Funcionamiento Y Seguridad

SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 15
For your own safety, turn switch "OFF" and
WARNING
remove plug from power source outlet be-
fore maintaining or lubricating your saw.
The cord and the tool should be wiped with a dry clean
cloth to prevent deterioration from oil and grease.
Certain cleaning agents and solvents can
WARNING
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents which contain
ammonia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
Turn switch "off" and always remove plug from the power source before trouble shooting.
WARNING
TRoUBle
will not start
Does not come
up to speed
excessive vibration

maintaining Your Tile Saw

maintenance

Troubleshooting

pRoBlem
Power cord is not plugged in.
Fuse or circuit breaker tripped.
Cord damaged.
Burned out switch.
Extension cord too light or too long.
Low house voltage.
Tile blade out of balance.
Tile blade bolt not tight.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
All repairs, electrical or mechanical, should
WARNING
be attempted only by trained repairmen.
Contact the nearest Factory Service Center or Authorized
Service Station or other competent repair service. Use only
identical replacement parts, any other may create a hazard.
accessories
Use only recommended accessories. Follow
WARNING
instructions that accompany accessories.
Use of improper accessories may cause hazards.
RemeDY
Plug in.
Replace fuse or reset tripped circuit breaker.
Have cord replaced by an Authorized Skil Service Center
or Service Station.
Have switch replaced by an Authorized Skil Service Center
or Service Station.
Replace with adequate cord.
Contact your electric company.
Discard tile blade and use different one, see page 11.
See "Tile Blade Installation", page 11.
15.