Clipper Operation; Beard Trimmer Operation - Unold 87815 Manual De Instrucciones

cLIPPer oPeratIon

1. Prepare the appliance as described in the
chapter „Before first use" and „Charging".
2. Make sure that skin and hair are clean and
dry before you start using the appliance. The
hair should furthermore be combed in order
to recognise the direction of hair growth.
3. Check if the desired comb is attached to the
appliance.
4. The adjustment wheel (2) allows adjusting
the desired hair length to seven positions.
Pos. Desired hair length in mm
Comb attach-
ment, small
1 2
2 5
3 8
4 11
5 14
6 17
7 20
5. Start with the longest adjustment and, if
necessary, carry out a test cut at a hidden
part of the body.

BearD trImmer oPeratIon

To obtain perfect results, always work against the direction of hair growth. Shaving will be easier if
you tense the skin of the part you want to shave with your free hand. After shaving we recommend
to cream the depilated parts with a mild body lotion in order to avoid skin irritation. If you have
sensitive skin or depilate sensitive parts, we recommend you to treat these parts only once in order
to avoid skin irritation.
1. Prepare the appliance as described in the
chapter „Before first use" and „Charging".
2. Detach the comb attachment pulling it off
the appliance.
3. Make sure that the skin is clean and dry
before you start using the appliance.
4. The adjustment button on the back of the
appliance (4) allows to select the desired
cutting length:
Pos. Cutting length in mm
1 1,5
2 1,0
3 0,5
Comb attach-
ment, big
22
25
28
31
34
37
40
6. Switch the appliance on pushing the button
EIN/AUS [ON/OFF].
7. Place the comb on the skin and work against
the direction of hair growth, if possible.
8. Cut the hair to the desired length. It is
recommended to shorten long hair with
scissors first. Therefore scissors and comb
are included in the supply.
9. While cutting your hair with the appliance,
stop from time to time and check the result
to ensure that you do not shorten your hair
too much.
10. In case you want to thin out your hair, use
the thin-out feature. Push the switch (3) to
the left. Now you can use the appliance as
usual, but your hair will only be thinned out.
To switch this feature off, push the switch to
the right again.
11. If hair gets caught in the shaving head,
switch the appliance off and clean the
shaving head as described in the chapter
„Cleaning and care".
12. After finishing the hair cut, switch the
appliance off pushing the button EIN/AUS
[ON/OFF].
13. Clean the appliance after every use.
5. Start with the longest adjustment and, if
necessary, carry out a test cut at a hidden
part of the body.
6. Switch the appliance on pushing the button
EIN/AUS [ON/OFF].
7. Place the appliance on the skin and work
against the direction of hair growth, if
possible. Do not use pressure on the app-
liance.
8. Legs: Shave your legs starting from the ankle
and moving upwards against the direction of
hair growth.
9. arms: The best results can be achieved
when working from the outside of the arm
to the inside.
15